ok, i have my alarm installed, (VIPER 500 ESP) how do i hook up the power door locks? can i just run my alarm output to the wires stated in the wiring diagam? people have said no, and tha ti need relays, 30A 12V (standard)
how do i wire up from the relays to allow the keyless entry to work?
action wire color location
Door Lock ][ORANGE / White [] Behind Fuse Panel at Door Lock Relays
Door Unlock ][Pink/Purple [] Positive Trigger
kind of hard to explain,. but how do i wire up the keyless entry? what wires to connect to etc.. thanks
-------------
-austin reed-
According to your information above ( without giving the make, model or year of the vehicle ) all you need to do is hook up the following:
- Door Lock ][ORANGE / White --------------- BLUE wire on the H2 plug
- Door Unlock ][Pink/Purple --------------- GREEN wire on the H2 plug
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
your vehicle has a posititve pulse door lock system. If you keyless entry unit gives you a negitive pulse you need to use two relays to make it work. First run your lock wire to the first relay on pin 85. Then run pins 87 on both relays and pins 86 on both relays to a fused 12 volt source.(5 amps) Run your unlock wire to pin 85 on the other relay. Then the pin 30 from each relay will go to the wire in the vehicle door lock system. (the relay that got the lock will go to the lock wire and so on.
Actually the viper alarms have both a pos and a neg output ( check in the owners manual ). The wires first supply a ground and then suplly a +12v. All you would have to use is the blue for lock ( blue is neg unlock and pos lock ) and the green for unlock ( green is neg lock and pos unlock). That alarm should have a small three pin plug with the middle pin empty. These wires are a low level output but should still operate the locks.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Just double checked and my spare 500esp ( I have that alarm too) and it says right on the back that there are two ouputs for each door lock wire. You don't have to program anything just hook it up like i said above.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
auex- so all i have to do it connect my output wires (BLUE AND GREEN) to the right wires within the car? (UNLOCK /LOCK)? its that easy? i thought i needed a relay, because the module wouldnt have sufficient power to do so? have you wired it up using only the blue/green wires before? has it caused problems? thanks
-------------
-austin reed-