How to wire gray wire from 530T to relay

You're going to want to interrupt the red wire for the shock sensor when the 530T is active so cut the red wire for the shock sensor and wire it like this:
85 -- gray (530T)
86 -- +12 volt constant
30 -- one side of cut red shock sensor wire
87a -- other side of cut red shock sensor wire
87 -- N/A


I wired the relay up as such, but it's not working correctly.

Are you sure this is the proper way to wire this up. According to the 530T owners manual, the gray wire "continues to output negative (-) ground for 5 seconds after the windows have stopped."

Well the alarm still goes off from the shock sensor when I use the remote to wind down the windows (same as before). Should the red wire to the shock sensor be hooked up to 87 or 30?

What alarm are you using?

I am using a Viper 600 ESP

-------------

Make sure that the 12 is constant. Also did you test it to make sure the relay is working. Because that is the way I have my sunroof wired up. And everything is a o kay. Make sure that the gray wire is sending ground.

Well i got it working. the problem is, when the relay "clicks" it makes the shock sensor move. I need to find a way to separate the vibration from the relay to the shock sensor.

-------------