Turn Signal Clicking

Printed From: the12volt.com
Forum Name: Relays
Forum Discription: Relay Diagrams, SPDT Relays, SPST Relays, DPDT Relays, Latching Relays, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=83539
Printed Date: May 28, 2024 at 1:25 PM

Topic: Turn Signal Clicking

Posted By: sbauld
Subject: Turn Signal Clicking
Date Posted: September 30, 2006 at 10:54 AM

I have installed the Avic Z1 Nav in a 2007 Tahoe. With the install of the GMOS-LAN-01 I was able to retain factory chimes ect. However the LAN01 instructions say that to retain turn signal clicking I would need to add an SPDT relay to the set up. I followed the following instructions.

1. Connect Pin 85 to the BLACK/ white wire of the 12 pin harness (lan01)

2. Connect Pin 86 to the 12 volt constant of the 12 pin harness (lan01)

3. Cover All other leads.

So far the only thing that I get is a clicking when the chimes turn on. I would appreciate if anyone has some advice on this. Thanks in advance for the help!

Replies:

Posted By: bellsracer
Date Posted: October 01, 2006 at 2:23 PM

Well that is what it is supposed to do, give you a click when the turn signals turn on and off. What effect were you looking for? Is it causing any trouble for you anywhere else?

-------------
Never send your ducks to eagle school.
The difference between ordinary and extraordinary is that little extra.
The 3Ls of life: Learn from the Past, Live for the Present, Look to the Future.

Posted By: hotwaterwizard
Date Posted: October 03, 2006 at 12:49 AM

I just did the same thing on my 64 VW Bug

I hooked the Relay to the Flasher and Ground.

-------------
John DeRosa (Hotwaterwizard)
Stockton California
When in doubt, try it out !