Print Page | Close Window

05 pontiac g5 remote start wiring

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100787
Printed Date: May 01, 2025 at 12:12 PM


Topic: 05 pontiac g5 remote start wiring

Posted By: red85
Subject: 05 pontiac g5 remote start wiring
Date Posted: January 05, 2008 at 3:28 PM

Hi there.  Does anyone have the wiring guide for a remote starter applicatin for an 05 Pontiac G5?

Phil




Replies:

Posted By: Velocity Motors
Date Posted: January 05, 2008 at 11:36 PM
Pontiac 2005 Pursuit 4DR Sedan
(Remote Start / Security / GPS)


Remote start / security / GPS
Wire/Function Colour Location/Description Polarity
PASSIVE ANTI-THEFT YES TRANSPONDER    SEE NOTES
12 VOLTS RED / black C3 plug on BCM in center console    +
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

IGNITION Yellow Ignition switch harness or C4 plug on BCM    +
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

ACCESSORY Brown Ignition switch harness or C4 plug on BCM    +
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

STARTER SEE NOTES       
   No connection is required for remote start. When accessory shuts down during the start cycle the vehicle will crank automatically.

TACH SIGNAL Use an injector wire       
FUEL INJECTOR Opposite from Pink At any injector on engine    AC
LOCK White In driver's kickpanel or C1 plug on BCM    -
   1-wire system. Ground (-) to lock and ground through 1.5K resistor to unlock. The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

UNLOCK White In driver's kickpanel or C1 plug on BCM    -
   1-wire system. Ground (-) to lock and ground through 1.5K resistor to unlock. The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

DOORPIN SEE NOTES       
   Driver's door (Gray/black) and Passenger door (Tan/white) are both found at the BCM on the passernerg side of the center console in the C1 (72-pin plug).

TRUNK PIN ORANGE / black C1 plug on BCM in center console    -
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

TRUNK RELEASE Tan C2 plug on BCM in center console    -
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

FACTORY ARM With OEM remote only       
FACTORY DISARM With OEM remote only       
BRAKESWITCH Lt.blue At switch above brake pedal    +
PARKLIGHTS Brown In driver's kickpanel or C1 plug on BCM    +
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

HAND BRAKE Lt.blue C1 plug on BCM in center console    -
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

HORN Tan Ignition switch or C2 plug on BCM    -
   The BCM is located in the passenger side of the center console. It has 4 plug running left to right C1 (72-pin), C2(72-pin), C3(40-pin) & C4 (not used).

CLUTCH SWITCH Yellow At clutch switch    Type 1
REVERSE LIGHTS Lt.green Under driver's side running board    +
PASSLOCK DATA White Ignition switch harness    DATA
PASSLOCK GROUND WHITE/ black Ignition switch harness    -




-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: red85
Date Posted: January 06, 2008 at 5:42 AM
So there's no connection for the crank/starter wire at all?  Are all these wires the same colour at the BCM as they are at the ignition harness?  It would certainly make for a cleaner installation if I could put all this stuff in the center console.




Posted By: Velocity Motors
Date Posted: January 06, 2008 at 10:02 AM
It is recommended that you go to the ignition for your ignition wires ( especially for the immobilizer bypass ).

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA





Print Page | Close Window