Print Page | Close Window

2007 pt cruiser convertible

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107446
Printed Date: May 13, 2024 at 8:48 AM


Topic: 2007 pt cruiser convertible

Posted By: crooozin
Subject: 2007 pt cruiser convertible
Date Posted: September 14, 2008 at 10:11 PM

Hi forum. First post.

I am having a hard time finding wiring diagrams and colors for my 2007 PT Cruiser convertible that actually match what I have. The ones posted here and elsewhere for non-convertibles don't seem to match up. For instance, my rr speakers are yellow/white stripe and GREEN/ black stripe- not listed that way anywhere I've seen so far, spent all day on this. At wits end. Can you help?

I'm looking for any and all diagrams, specifically starter 1/2, acc, ign, door/windows, radio/stereo, and for the top. Thank you in advance.

Regards,

C




Replies:

Posted By: ckeeler
Date Posted: October 07, 2008 at 3:13 PM

I hope this helps you out.

STARTER

PINK/LIGHT BLUE (+)

@ IGNITION HARNESS

  
 STARTER 2 PURPLE / BROWN (-) See NOTE *1 @ IGNITION HARNESS,

IGNITION 1

 PINK/WHITE (+)  @ IGNITION HARNESS  
    
    
 ACCESSORY /HEATER BLOWER 1 Uses the PURPLE / BROWN Starter #2 wire, See NOTE *2  @ IGNITION HARNESS,   
     
    
    
 PARKING LIGHTS ( + ) WHITE/ PURPLE (+)  IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE   
 POWER LOCK LIGHT GREEN/ DARK GREEN (1-Wire Door Lock System) See NOTE *3

IN DRIVERS KICK PANEL or INSTRUMENT CLUSTER, Connector 2, Pin 18,

 
 POWER UNLOCK Same wire   
 LOCK MOTOR WIRE TAN/DARK BLUE (+)  IN DRIVERS KICK PANEL   
 DOOR TRIGGER See NOTE *4  IN EACH KICK PANEL or INSTRUMENT CLUSTER, Connector 2  
 DOMELIGHT SUPERVISION YELLOW/WHITE (+), Requires Relay  IN DRIVERS KICK PANEL   
 TRUNK RELEASE TAN/LIGHT GREEN (-) to TAN/DARK GREEN (-) See NOTE *5, Requires Relay  IN DRIVERS KICK PANEL   
    
 HORN DARK GREEN/ PURPLE (-)  @ HORN SWITCH   
 TACH ANY wire NOT DARK GREEN/ ORANGE  @ ANY FUEL-INJECTOR   
    
 BRAKE DARK GREEN / WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL   
 FACTORY ALARM DISARM  DISARMS with FACTORY REMOTE ONLY!!     
 ANTI-THEFT CHRYSLERS SENTRY TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module and Extra Ignition Key  @ IGNITION SWITCH TUMBLER   
NOTES

NOTE *1 The STARTER #2 wire requires a (-) Negative thru a 180 Ohm resistor, this connection will also require a Relay to connect.

NOTE *2 The ACCESSORY wire Requires a (-)Negative thru a 610 Ohm resistor, this Accessory wire is the STARTER #2 wire and will also require an extra Relay.

NOTE*3 This vehicle uses a 1-Wire Door Locking System, the LOCK requires a (-) Negative thru a 1000 Ohm Resistor and the UNLOCK requires a (-) Negative thru a 250 Ohm resistor, depending on the unit some will also require 2 relays.

NOTE *4 The DRIVERS DOOR is a TAN (-) to PURPLE (-) in Pin 3, the PASSENGER DOOR is a TAN/RED (-) to PURPLE / WHITE (-) in Pin 11. The DRIVERS REAR DOOR is a TAN/ORANGE (-) to PURPLE / GRAY (-) in Pin 5. The PASSENGER REAR DOOR is a TAN / YELLOW (-) to PURPLE / YELLOW (-) in Pin 6. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE.

NOTE *5 On CONVERTIBLE's the TRUNK RELEASE is at the Switch in the Glove box, on Wagon's test this wire while opening the hatch from the handle on the rear hatch, the TRUNK/HATCH Release Motor wire is a TAN / YELLOW (+) in the Drivers Kick Panel.





Print Page | Close Window