2004 buick rendezvous radio wiring info

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107567
Printed Date: October 31, 2024 at 7:05 PM

Topic: 2004 buick rendezvous radio wiring info

Posted By: Rovari
Subject: 2004 buick rendezvous radio wiring info
Date Posted: September 20, 2008 at 9:32 AM

Hello to all,
I am going to install an Apline head unit into a 2004 Buick Rendezvous (basic radio/no On Star).
I was hoping to connect the steering wheel controls and bypass the fatory amplifier as well.
I am not familiar with this vehicle and was hoping someone can explain what is required for the installation.
I am assuming that I will need the following:
1. Double din to single din adaptor
2. Antenna adaptor
3. Steering wheel module
4. Amp bypass module(or hardwire speakers if it is possible)
5. Male radio harness

I have searched the forums looking for a radio wiring guide and have not found any information.
If anyone is able to provide the radio wiring info that would be great!
Thanks to all in advance for any help.

Rovari

Replies:

Posted By: megaman
Date Posted: September 20, 2008 at 1:49 PM

Scosche kit GM-K420, or Metra 99-2003. Antenna Adapter Metra GM-10,

You'll need an interface because your warning chimes are audio controlled and there's no 12v acc power.

Interfaces: Metra GMOS-01, or Peripheral GMCO.

The interface will retain the factory amplifier, but you can wire around it if you desire, just run speaker wires to each individual speaker.

Steering wheel interface: PESWIAKJC for your alpine.

Posted By: Rovari
Date Posted: September 20, 2008 at 2:06 PM

THANKS!
Is anyone aware of a dealer in Toronto that may have these acessories?