2008 honda accord parking light

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107989
Printed Date: May 12, 2025 at 11:59 PM

Topic: 2008 honda accord parking light

Posted By: nima
Subject: 2008 honda accord parking light
Date Posted: October 07, 2008 at 8:57 PM

2008 Accord

need wire location for Park light +Positive,

and how to wire the Trunk relese, my remote start has <"Bookman Old Style">(-) 200mA trunk release

TRUNK RELEASE

Orange

In green 42-pin plug top of fusebox +

Replies:

Posted By: i am an idiot
Date Posted: October 07, 2008 at 9:04 PM

Convert a Negative Output to a Positive Output

If you have a switch or an alarm or keyless entry that has a negative output that you wish to use to switch a device that requires 12V+ such as a horn, dome light, parking lights, head lights, hatch release, etc., wire a relay as shown below to convert the negative output (trigger) to a positive output. posted_image

Here's the same configuration showing a negative output from an alarm or remote keyless entry used to activate a trunk release solenoid that requires 12V+ to release the trunk. posted_image

Convert a Positive Output to a Negative Output

If you have a switch or an alarm or keyless entry that has a positive output that you wish to use to switch a device that requires a ground such as a horn, dome light, parking lights, head lights, hatch release, etc., wire a relay as shown below to convert the positive output (trigger) to a negative output. posted_image

Here's the same configuration showing a positive output from an alarm or remote keyless entry used to activate a vehicle's parking light relay that requires a ground to turn the lights on. posted_image

Low Crr Pk Lights

GRAY

(-)

AT LIGHT SWITCH

Posted By: nima
Date Posted: October 07, 2008 at 9:11 PM

So i need to use this, and they dont have positive park light wire, thanks for help

Here's the same configuration showing a negative output from an alarm or remote keyless entry used to activate a trunk release solenoid that requires 12V+ to release the trunk.

Posted By: i am an idiot
Date Posted: October 07, 2008 at 9:36 PM

Convert a Positive Output to a Negative Output

You asked for a positive parking light wire, there is only a negative. I am assuming that your alarm has a positive output for light flash. You will need to use the above diagram to convert the positive out of the alarm to a negative out that will be accepted by the car.

The diagram you posted is what you need to do for the trunk release.