05 toyota tundra alarm trigger problem
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112736
Printed Date: May 12, 2025 at 11:59 PM
Topic: 05 toyota tundra alarm trigger problem
Posted By: desh187
Subject: 05 toyota tundra alarm trigger problem
Date Posted: March 27, 2009 at 8:40 PM
Installed a Black Widow Z1 alarm/autostart on a 2005 Toyota Tundra.Alarm (siren)goes off a minute after arming.I have used the individual wires at bcu dr-gray/red gray plug,pass frt lt GREEN/ blk black plug,Lr RED / white gray plug and Rr RED / white black plug.
Temporarily i have tapped into the supervision blue/black wire.The reason iam saying temporarily is because of another issue which is the auto rearm feature when activated even after opening a door,rearming does not cancel,led keeps blinking and arms the alarm.The same happens with individual wires.
Any feedback will be very much appreciated.
Replies:
Posted By: howie ll
Date Posted: March 28, 2009 at 3:50 AM
It definately sounds like a door contact problem, the re-arming problem points that way, test all your door contacts the dome supervision, and your grounds, a bad ground could also cause this, last of all make sure the plugs on the alarm module are all pushed home properly.
|