I have a problem to find the Lock/Unlock wire on the master switch on the driver door. My remote start/alarm unit is CM5000 of Compustar and Lock/Unlock is (-) pulse. I connected RS Lock wire to " orange" on the driver door switch connector and RS Unlock wire to " Brown" wire on the driver door switch connector and remote Lock/Unlock not thing happen? Do some body know which wires are Lock/Unlock on Accord 09? Please help.
2009 Honda Accord Last Update: 2/12/2009
Circuit Wire Color Location
Constant 12 volts WHITE IGNITION SWITCH OR TOP FUSE BOX @ *
Ignition 12 volts BLUE IGNITION SWITCH OR TOP FUSE BOX @ *
Starter YELLOW IGNITION SWITCH OR TOP FUSE BOX @ *
Dome Light DR PIN PINK,TRUNK / HATCH WHITE BOTH ARE (-) BOTTOM **
Trunk Pin WHITE (-)16 PIN L GRN CONN DRIVER FUSE BOX PIN 5
Parking Lamp RED (+) 16 PIN L GRN CONN DRIVER FUSE BOX PIN 11
Lock ORANGE IN THE DRIVERS DOOR #201
Unlock BROWN *** IN THE DR DOOR W DOUBLE PULSE
#201- See Negative Pulse Door Lock Diagram. * GREEN PLUG ** OF FUSE BOX WHITE PLUG *** From Installer- Unlock Requires BROWN And WHITE To Be Diode Isolated And Double Pulse For Unlock. Wires Found At Door Motor DOOR LOCKS Can Be Done With A Module Call For Details.
Do you mean that I need a module for door lock even I have remote/alarm combo could send out double pulse for Lock/Unlock? Back to the color code, I did connected the L brown and white wires located on White conn behind the Key driver switch to my R/S Unlock wire but nothing happen with single and double pulse. For the Lock wire on the forum wire diagram is "Orange" so I did conected that wire to my R/S Lock wire and still nothing happen too. You said " Wires Found At Door Motor DOOR LOCKS Can Be Done With A Module Call For Details." which No. I could contact you ? Thanks very much.
the dlpk from bypasskit.com will work for door locks,factory arm,disarm and defrost if i remember when i did the car