does anyone know which wire to connect the factory disarm wire to from a remote start, keyless entry system
I have the system installed along with the xk531 to bypass the skim module but the vehicle will not stay running and I suspect the factory security is not disarmed correctly
the wiring diagram from here shows a Ltgrn/orange wire in the drivers door lock switch if I am reading right, but I have no wire that color in the switch
thanks in advance
-------------
WE'LL TRY ANYTHING ONCE
The XK531 already disarms through data. This doesn't look like it's your problem. When the Jeep tries and dies, does the Immobilizer LED flash ? If so, you do not have the wraps tight enough or not enough around the key cylinder.
XK531 - JDL 1.00 (1999 Jeep Grand Cherokee)
W2W
AV-Domelight Activation
AV-Horn Chirp activation
CC-Power Mirror memory
CC-Power Seat Memory
CC-Radio Channel Memory
DL-Arm Factory Security
DL-Disarm Factory Security
DL-Door Lock Control
DL-Door Unlock
DL-Driver Priority Unlock
PK-Immobilizer Bypass-RFID No Key Req'd
RS-RAP Shut Down (Remote ACC Power)
SS-Entry Monitoring ALL Door Pins
SS-Entry Monitoring Front Door Pins
SS-Entry Monitoring Trunk/Hatch Pin
D2D
AV-Domelight Activation
AV-Horn Chirp Activation
CC-Power Mirror Memory
CC-Power Seat Memory
CC-Radio Channel Memory
DL-Arm Factory Security
DL-Disarm Factory Security
DL-Door Lock Control
DL-Door Unlock
DL-Driver Priority Unlock
FOB- CAN alarm control w/FOB remote
PK-Immobilizer Bypass-RFID No Key Req'd
RS-RAP Shut Down (Remote ACC Power)
SS-CAN Alarm control w/ FOB remote
SS-Entry Monitoring ALL Door Pins
SS-Entry Monitoring Front Door Pins
SS-Entry Monitoring Trunk/Hatch Pin
ST-Door Locks Status
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
You know now that you mention it I was able to program the xk531, I saw the factory security light on the dash go out after programming the two keys and the xk531, but I have not been able to get into user setup or have I ever seen the led do anything but stay on all the time
will try wrapping the key cylinder again and reprogramming, thank you for your input
-------------
WE'LL TRY ANYTHING ONCE