2006 infinity g35 wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118409
Printed Date: May 11, 2025 at 12:07 AM
Topic: 2006 infinity g35 wiring
Posted By: misterjimbo
Subject: 2006 infinity g35 wiring
Date Posted: December 10, 2009 at 3:47 PM
I could not find any info on this car.
no intelli key and non push button start
is it the same as the 2006 350Z?
can you integrate the window down feature on the aftermarket remote?
Thank you gents
Replies:
Posted By: KPierson
Date Posted: December 10, 2009 at 6:03 PM
| 12 VOLT CONSTANT | WHITE/ BLUE (+) | IGNITION SWITCH HARNESS | | | STARTER | RED / WHITE (+) or WHITE/ RED (+) See NOTE *1 | IGNITION SWITCH HARNESS | | | STARTER 2 | WHITE/ GREEN (+) See NOTE *1 | IGNITION SWITCH HARNESS | | | IGNITION 1 | BLACK/ RED (+) | IGNITION SWITCH HARNESS | | | IGNITION 2 | N/A | | | | IGNITION 3 | N/A | | | | ACCESSORY /HEATER BLOWER 1 | WHITE/ BLACK (+) | IGNITION SWITCH HARNESS | | | ACCESSORY /HEATER BLOWER 2 | N/A | | | | KEYSENSE | N/A | | | | PARKING LIGHTS ( - ) | N/A | | | | PARKING LIGHTS ( + ) | RED / BLUE (+) | IN DRIVERS KICK PANEL, HARNESS heading to REAR of Vehicle | | | POWER LOCK | YELLOW (TYPE B) See NOTE *2 | @ DRIVERS DOOR MODULE in DRIVERS DOOR | | | POWER UNLOCK | LIGHT BLUE (TYPE B) Requires Double Pulse See NOTE *2 | @ DRIVERS DOOR MODULE in DRIVERS DOOR | | | LOCK MOTOR WIRE | PURPLE (+) | @ BCM, 16-Pin Plug Pin 30, See NOTE *4 | | | DOOR TRIGGER | YELLOW (-) and PINK (-) Use both, See NOTE *3 | @ BCM, WHITE 12 PIN PLUG, See NOTE *4 | 14301_G35-COUPE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf | | DOMELIGHT SUPERVISION | TURNS ON with UNLOCK | | | | TRUNK RELEASE | PINK (-) | @ BCM, BROWN PLUG, PIN 76, See NOTE *4 | | | SLIDING POWER DOOR | N/A | | | | HORN | GREEN/ BLACK (-) | @ STEERING COLUMN HARNESS | | | TACH | ANY WIRE NOT BLACK or WHITE/ BLUE | @ ANY IGNITION COIL | | | WAIT TO START LIGHT | N/A | | | | BRAKE | PINK/BLUE (+) | @ SWITCH ABOVE BRAKE PEDAL | | | FACTORY ALARM DISARM | DISARMS WITH UNLOCK, Single Pulse Disarms | | | | ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER | |
| NOTES | NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE *2 TEST THESE WIRES WHILE TURNING THE KEY IN THE DRIVER DOOR KEY CYLINDER.
NOTE *3 THE DRIVERS DOOR IS A YELLOW (-) PIN 14, THE PASSENGER DOOR IS A PINK (-) PIN 10. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM
NOTE *4 THE BCM (BODY CONTROL MODULE) IS LOCATED IN THE DRIVERS KICK PANEL, THE BCM HAS 4 WHITE PLUGS AND 1 BROWN PLUG. |
You can control the windows with extended (-) triggers on the lock / unlock wires. ------------- Kevin Pierson
Posted By: misterjimbo
Date Posted: December 10, 2009 at 6:14 PM
thank you sir.
|