Print Page | Close Window

1997 Chevrolet Silverado Radio Wiring Diagram

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120090
Printed Date: May 03, 2024 at 12:18 PM


Topic: 1997 Chevrolet Silverado Radio Wiring Diagram

Posted By: seblicar
Subject: 1997 Chevrolet Silverado Radio Wiring Diagram
Date Posted: February 12, 2010 at 8:19 PM

hey, i was wondering if someone can chow me a diagram of the speaker wires running from the stereo of a 97 silverado to the tower speakers in the back. if someone can send me a diagram (if they have one or where to get one) to lancer-evo-8@hotmail.com or reply back and tell me (w/ detail) where the wires are.

the reason im asking is that i just want to use the origonal wires and use them for some speaker boxes that i will put underneath the back seats.

thanks,
Seblicar



Replies:

Posted By: tommy...
Date Posted: February 12, 2010 at 8:22 PM

They should be running in the sill on each side of the truck...It is super easy to run leads down the sides...I dont know of anythin g thats going to show you exactly...They just tell you a general location...

Battery ORANGE (+) RADIO HARNESS
posted_image Accesory YELLOW (+) RADIO HARNESS
posted_image Ground BLACK (-) RADIO HARNESS
posted_image Illumination GRAY (+) RADIO HARNESS
posted_image Dimmer BROWN (+) RADIO HARNESS
posted_image LF Speaker (+) TAN
posted_image LF Speaker (-) GRAY
posted_image RF Speaker (+) LIGHT GREEN
posted_image RF Speaker (-) DARK GREEN
posted_image LR Speaker (+) BROWN
posted_image LR Speaker (-) YELLOW
posted_image RR Speaker (+) DARK BLUE
posted_image RR Speaker (-) LIGHT BLUE
posted_image Steering Cntrls NO
posted_image Speed Cntrl NO
posted_image Radio Security YES



-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!




Posted By: tommy...
Date Posted: February 12, 2010 at 8:23 PM
Are you adding additional speakers or disconnecting the rears and adding the ones in the boxes...Is it a factory radio...? What kind of speakers...?

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!




Posted By: tommy...
Date Posted: February 12, 2010 at 8:26 PM
So basically you will have to pop the running board plastic off on each side of the truck and look through the several wires that should run along the sill...Or just add new wires from the back of the stereo and down the sides of the truck...You could even make a small slit in the carpet so the wires only show where they come out of the slice right in-front/behind the speakers...

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!




Posted By: seblicar
Date Posted: February 13, 2010 at 10:39 AM
for the sills, are you talking about the sides where the carpet meets the door sills? if so, we already have looked on both sides and there isn't any wires. i am running a pioneer radio w/ stock speakers. i will be diconnecting the rear speakers to put new ones in boxes underneath the back seat. for the manufacture of the speakers, i can't remember off the top of my head. we found out that inside the cab on the ceiling (or however you spell that), towards the back there is a panel that we took off. once we pulled that off, there was some wires running to the right side speaker. so i think that the wires are wired to the top of the door frame panels and once the left speakeres are connected, they other set of wires run to the other side of the truck for the right. FYI the wires running to the right side were dark blue and light blue.




Posted By: tommy...
Date Posted: February 13, 2010 at 12:31 PM
Sometimes they will branch off and go under the seats...If your really having a tough time finding them...Disconnect behind the radio and run two leads down the sills...The wire does not have to be thick...Once you get to the speakers make a slit in the carpet and you can use a coat hanger...etc...put into the slit you made and push over to where the carpet meets the sides...They could be going up the a/b pillars...

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!





Print Page | Close Window