I installed a ALERT 350R in this vehicle and all dash lights come on but no crank and I have not been able to find a wiring schmatic for this exact vehicle I also install a 791 by pass to the pass lock system can someone please send me a detailed instructions on how to install this ive read it only takes 30 min but i dont see how if the body control module is under the rear seat ? Thank you
Not sure what a 791 bypass is but if it cuts the Passlock wires, I would suggest picking up a GMBP. The bypasses that cut the wires work fine, but can be a pain to troubleshoot, especially if you are not familiar with the Passlock type systems. If you pick up a data based bypass it's one connection to the OBDII connector and you are done.
-------------
Installer, IT support, and FFL. I need less hobbies.
the 791 module is a by pass for the passlock 2 system> now im not sure what a GMBP is.I guess I will look for it on e-bay I was to the understanding that this was i simple install as other post say, as well as it only taking 30 mins ? Thank you for the reply.
I finally was able to get through to tech support at alert. There 791 by pass module for the pass lock 2 system instructs you to connect the yellow wire to (+) positive voltage. what they didnt say was that both wires have voltage. one has high voltage the other is low voltage and the low was the wire I need .when i moved this wire the the system worked ! hope this helps anyone else that may run into this problem .
also if you do use the 791 pass lock bypass module and it has a red LED.When the module has learned the key resistance the red LED should go out . If it stays on it did not read the resistance . Hope this will help someone else.