2000 toyota funcargo/yaris verso
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=121221
Printed Date: April 27, 2024 at 12:14 PM
Topic: 2000 toyota funcargo/yaris verso
Posted By: compay
Subject: 2000 toyota funcargo/yaris verso
Date Posted: April 08, 2010 at 8:01 AM
hi looking for wiring diagram for my 2000 toyota funcargo/yaris verso thanks
Replies:
Posted By: howie ll
Date Posted: April 08, 2010 at 2:13 PM
What do you need to know?
Posted By: compay
Date Posted: April 09, 2010 at 2:54 PM
am installing a viper 160xv alarm and am getting problems with the door lock interface to unlock and lock the car.
Posted By: compay
Date Posted: April 09, 2010 at 2:58 PM
it's a 160vx not xv any help i can get with it would be greatfull
Posted By: howie ll
Date Posted: April 09, 2010 at 4:10 PM
Lock/un;lock are low current neg. pulse, either in lock module to right of inst. panel or driver's kick panel.
Posted By: compay
Date Posted: April 10, 2010 at 7:07 PM
i found a door lock module but i need to know which wire is for what it have and 8 pin connector to it
Posted By: howie ll
Date Posted: April 11, 2010 at 2:20 AM
Dead easy. Take your DMM, set it to ohms, place the black lead to ground, shut other doors and latch the driver's door, place red probe on each wire in turn at the plug, one will lock, one will unlock. This job is faster using a dedicated bulb tester such as the Snap On unit.
This is about a 1 1/2 hour job, I can't hold your hand, you must do some thinking.
Posted By: compay
Date Posted: April 11, 2010 at 3:03 PM
did all that already but when i connect the wire from the alarm that should operate it (lock/unlock) the doors nothing happen
Posted By: howie ll
Date Posted: April 11, 2010 at 4:53 PM
Look at your wiring. The system is type B
Posted By: compay
Date Posted: April 12, 2010 at 3:09 PM
don't understand the term used
Posted By: howie ll
Date Posted: April 12, 2010 at 4:51 PM
Look at your install manual that you get with the alarm, type A = pos pulse to trigger the locking, type B = neg pulse to trigger the locking. From your comments I really don't think you should be doing this, it's about the simplest vehicle to install with one of the simplest alarms on the market. If you've no idea how to do the locks, it bodes ill for your car... = £$£$ to put right afterwards.
Posted By: t&t tech
Date Posted: April 12, 2010 at 5:01 PM
That's negative trigger or type b locking system, the wires will be easily found in the driver kick well, posibbly Blue/white and blue / YELLOW, but test it's sure to be there!
-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF.
PSALMS 37:5
Posted By: compay
Date Posted: April 13, 2010 at 8:06 PM
i found all the wires that lock and unlock the car
|