remote start wiring for 2005 pontiac g6

I am in need of the wiring for an 05 G6. Any tips are greatly appreciated as it has been a while since working on any newer GM products. (I used to do this professionally) Thanks in advance.

Battery RED / WHITE (+) IGNITION SWITCH HARNESS Ignition 1 PINK (+) IGNITION SWITCH HARNESS Accessory 1 BROWN (+) IGNITION SWITCH HARNESS Starter 1 START WIRE NOT NEEDED Anti-Theft Type GM PASSKEY III® VEHICLE IMMOBILIZER Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER Tachometer TAN (-) AT FUEL INJECTOR OR PCM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD Crankshaft Sensor LIGHT BLUE/BLACK (AC) AT PCM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD Camshaft Sensor BROWN / WHITE (AC) AT PCM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD Speed Sense YELLOW (-) AT EBCM MODULE BETWEEN BRAKE BOOSTER AND DRIVERS SIDE SHOCK TOWER UNDER HOOD Parking Lights BROWN / WHITE (-) AT BCM MODULE BEHIND TRIM AT FRONT OF CENTER CONSOLE ON PASSENGER SIDE Brake Lights WHITE (+) AT BCM MODULE Reverse Lights LIGHT BLUE (-) AT BCM MODULE BEHIND TRIM AT FRONT OF CENTER CONSOLE ON PASSENGER SIDE Horn TAN (-) AT BCM MODULE BEHIND TRIM AT FRONT OF CENTER CONSOLE ON PASSENGER SIDE

I do not know how long it has been since you did a remote start, but I am guessing by reading that the start wire is not needed to do a remote start, that this is not going to be an easy car for you to try and get back into the game with.

Here is a link to Bulldog Secutity:  https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp   They have the wire listing and some nice pictures for your car.  With the right bypass module, the car can be fairly easy to do.

You will need a bypass module for your car, it has PK3+ immobilizer.  You can save yourself some time by spending a little more for the bypass and get one that takes care of the door locks, trunk, factory alarm, etc.  Here is a link to Fortin offerings for your car:  https://ifar.ca/en/vehicles/pontiac/g6/2005/  Their modules come pre-loaded and ready to go.  The DEI DLPK  is the same thing.  https://www.xpresskit.com/product.aspx?productid=122

Good luck.

-------------
Soldering is fun!

Being slightly anal I noticed that tach in the above list is shown as NEG rather than AC is this a typo?
Also a question I'm hoping can be answered, could you use either crankshaft or camshaft positional sensors to obtain a tach reading?

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.