2010 audi s4 remote start wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123641
Printed Date: May 03, 2024 at 4:10 AM
Topic: 2010 audi s4 remote start wiring
Posted By: stang351w
Subject: 2010 audi s4 remote start wiring
Date Posted: September 23, 2010 at 1:47 PM
Hello, I'm wondering if anyone has the wiring info for me to install a remote starter system into a 2010 audi S4. this does not have the push button start. also if anyone has any tips fo rthis car would be greatly welcomed lol
-------------
Tri County KustomZ
certified installer
Replies:
Posted By: howie ll
Date Posted: September 23, 2010 at 5:03 PM
Sorry but I have a tip in two parts, RUN! If not it's all CAN systems, don't even think about hard wiring.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: stang351w
Date Posted: September 23, 2010 at 5:58 PM
are they really that bad? i've got installer companion here and for the 2008 S4 didn't look to bad..a little bit of work with the bypass. but i guess until i see the wiring needed wont know lol but that's for the tip anyway
-------------
Tri County KustomZ
certified installer
Posted By: howie ll
Date Posted: September 24, 2010 at 1:33 AM
Door, trunk and hood triggers + locking are at the rear right in the lock/alarm control box, if you can find a control unit from Fortin etc. that does the locks, by-pass etc. you're on a winner
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: stang351w
Date Posted: September 24, 2010 at 8:08 AM
alright thanks....i was planning on useing the idatalink bypass...according to the site it does all the door locks and such....i don't suppose you've got the wiring info fo rthe car? i also forgot to mention it's a standard
-------------
Tri County KustomZ
certified installer
Posted By: howie ll
Date Posted: September 24, 2010 at 9:21 AM
No sorry, your general wiring should be the same but I'll bet the CAN protocols have changed so make sure the by-pass is bang up to date, also if your by-pass is the key in the box type, make sure you obtain the black plastic valet key and that it's programmed to that vehicle.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|