nissan micra

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125609
Printed Date: May 04, 2025 at 8:20 PM

Topic: nissan micra

Posted By: gpeen
Subject: nissan micra
Date Posted: January 11, 2011 at 12:58 PM

wiring diagrm for a 2004 UK nissan micra 1.2 se

thanks, george

Replies:

Posted By: howie ll
Date Posted: January 12, 2011 at 4:46 AM

Is this the Mk ll or Mk lll, shape?

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: gpeen
Date Posted: January 12, 2011 at 5:12 AM

not sure but i havent seen a newer shape

george

Posted By: howie ll
Date Posted: January 12, 2011 at 10:04 AM

Assuming this is for an alarm, from memory:-
Remove top of dashboard, remove both "A" pillar side trims and then prise off dashboard top.
Top left is a module with various plugs.
These will give you lock and unlock (neg pulse) 2 or 4 door triggers, trunk (rear hatch) and possibly hood (bonnet) trigger. They have to be back dioded (look up Ford 1076 in the down loads on this site) then dioded together.
Also indicators, constant 12Volts and ignition. Remote start functions are controlled from the ignition switch loom via a 556UW, wired as European.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: gpeen
Date Posted: January 13, 2011 at 11:27 AM

thank you howie, any one know colour of wires?

Posted By: howie ll
Date Posted: January 13, 2011 at 11:40 AM

You got to be kidding! 12volt snap-on test light, best for this job. The bulb in it will trigger the locks.
Do what I did all three times I've done alarms on this baby, TEST
On a more serious note, nearside engine bay, there should be a grommet to bring in the siren and bonnet switch (unless the bonnet trigger is on the BCM module, test).
Apart from the siren and if needed, remote start, the whole job is done by sitting in the passenger seat, no bending down or praying at the dashboard. posted_image

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: gpeen
Date Posted: January 13, 2011 at 11:47 AM