Hi, looking for help with wiring on my '01 F250, diesel, crew cab.
Putting in a viper 350 Responder. Specifically door lock/unlock wires, other wiring diagrams appreciated. I am a pro tech, just not a Ford/alarm tech!
Search in the forum comes up vague, so.
Thank you.
-------------
tfbike
The door locks are either Type B (-) or Type C ( REV ) depending on whether or not the truck came with Factory
Keyless Entry. Here is the info from Bulldog Security :
POWER LOCK PINK / YELLOW (TYPE C) See NOTE *1 See NOTE *1
POWER UNLOCK PINK/LIGHT GREEN (TYPE C) See NOTE *1 See NOTE *1
NOTE *1 Vehicles with FACTORY KEYLESS ENTRY are a TYPE "B" Door locking system, wire are located in a GREY
Molex plug on the RIGHT side of the Steering column, vehicles without FACTORY KEYLESS are a TYPE "C" Door
locking system, when doing TYPE C Locks, use the DRIVERS side SWITCH when TESTING. Wires are located in the
DRIVERS DOOR HARNESS.
Wiring Diagram for Type B : https://www.the12volt.com/doorlocks/page3.asp#3wp
Wiring Diagram for Type C : https://www.the12volt.com/doorlocks/page3.asp#5w
Using a DEI 451M Relay Module will make things easier. They are currently available "OnLine" for $5, delivered. Here is a link to the 451M install guide : https://www.the12volt.com/installbay/file.asp?ID=726
-------------
Soldering is fun!
Thanks for the reply. I forgot to add it has factory keyless entry, but no security.
-------------
tfbike
Factory Keyless Entry should make it easier. Not familiar with the Viper 350 but most units can connect directly to Type B (-) vehicle lock wires. If the Viper has the Push / Pull ( + / - ) lock outputs, you might want to place a diode in line.
-------------
Soldering is fun!