wiring, nonamp 2010 hyundai accent
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129643
Printed Date: May 02, 2025 at 12:06 PM
Topic: wiring, nonamp 2010 hyundai accent
Posted By: addicted
Subject: wiring, nonamp 2010 hyundai accent
Date Posted: December 10, 2011 at 11:14 PM
2010 hyundai accent, 4door, base model. Im looking for a switched 12v. Source to use as a remote for a amp i installed.
-------------
it calls me...
Replies:
Posted By: howie ll
Date Posted: December 11, 2011 at 6:35 AM
Is there an antenna remote either wire or terminal on the radio which goes 12v+ when the radio is turned on?
Otherwise, the ACC wire at the ignition switch, fuse box or rear of the radio.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: i am an idiot
Date Posted: December 11, 2011 at 8:55 AM
 |
Battery |
|
RED |
|
(+) |
|
RADIO HARNESS |
|
|
|
Accesory |
|
GREEN |
|
(+) |
|
RADIO HARNESS |
|
|
|
Ground |
|
BLACK & GRAY/BLACK |
|
(-) |
|
RADIO HARNESS |
|
|
|
Illumination |
|
YELLOW |
|
(+) |
|
RADIO HARNESS |
|
|
|
Power Antenna |
|
PINK |
|
(+) |
|
RADIO HARNESS |
|
|
|
Amp Turn On |
|
BLUE |
|
(+) |
|
RADIO HARNESS |
|
|
|
LF Speaker (+) |
|
BROWN |
|
 |
|
LF Speaker (-) |
|
WHITE |
|
|
|
RF Speaker (+) |
|
BLACK |
|
|
|
RF Speaker (-) |
|
YELLOW |
|
|
|
LR Speaker (+) |
|
RED |
|
|
|
LR Speaker (-) |
|
BLUE |
|
|
|
RR Speaker (+) |
|
ORANGE |
|
|
|
RR Speaker (-) |
|
GREEN |
|
|
|
Amp Location |
|
RIGHT SIDE OF TRUNK/CARGO AREA BEHIND TRIM |
Posted By: addicted
Date Posted: December 11, 2011 at 12:43 PM
Hm I was hoping to tap off of the fuse box source.
-------------
it calls me...
Posted By: addicted
Date Posted: December 11, 2011 at 12:45 PM
The green wire should be the same for a base model that has no stock amp?
-------------
it calls me...
Posted By: howie ll
Date Posted: December 11, 2011 at 5:21 PM
Help us here and start testing yourself.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: addicted
Date Posted: December 14, 2011 at 10:06 AM
I assumed some one might have a location without getting behind the stock deck. Im aware of diagram, but it did not specify for the base model.
-------------
it calls me...
Posted By: howie ll
Date Posted: December 14, 2011 at 10:11 AM
The answers you were given here were from pros, therefore the correct way.
If you use an ignition or ACC wire, you're likely to induce a whine through the amp when the radio is switched off.
I might add we are here to give you advice not hold your hand so buy a tester and pull the head unit.
What's next? Where are the grommets in the bulkhead?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: addicted
Date Posted: December 20, 2011 at 5:41 PM
Hey buddy relax and smoke some ganja. Im not a pro. A stupid question is not asked.
-------------
it calls me...
Posted By: addicted
Date Posted: December 20, 2011 at 7:51 PM
Some of the wires are not the same. There is no remote wire for the non amplified base model 4 door accent 2010. How ever I did tap off the green wire and no engine noise. I did find it very easy to get the stock deck out. Atleast I got to post my solved problem for anyone that has base model amp install
-------------
it calls me...
|