Remote Start on Neon

Greetings.
I just purchased an alarm system with a remote engine starter and is planning to install it on my '95 Dodge Neon. Also, I will be installing door actuators. Could you guys help me out with the wiring diagram for these installations, and probably some pointers, too? Thanks, would really appreciate the help.

Hey,

Here's a link to your car's wiring information that you'll need (like where to find 12v constant, 12v switched...stuff like that).

As for wiring the actuators, it depends on what type of alarm you're installing. If it has built-in relays for the door locks, then you won't need separate relays. If it doesn't have built-in ones, then you'll need two relays to wire the actuators to the alarm.

Here's the actuator wiring diagram (It's the one that says for Actuators/Reverse Polarity)

Write back if you have more questions.

Thanks so much, these are really gonna help me a lot. By the way, the actuators I just purchased are 2-wire type, would I still be using the "reverse polarity" diagram?
Again, thanks!

No problem.
Yes, you'll still be using that diagram.
But you should see if the alarm has built-in relays first for the door locks....if they do, then you won't even need the extra relays. The manual should tell you if it does or not.