2009 pontiac vibe gt steering wheel input

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132422
Printed Date: May 13, 2025 at 1:03 AM

Topic: 2009 pontiac vibe gt steering wheel input

Posted By: cq358
Subject: 2009 pontiac vibe gt steering wheel input
Date Posted: October 19, 2012 at 12:33 AM

Could anybody please provide me which pin on the OEM radio unit is responsible for audio control input (2009/2010 Vibe GT) should come as a standard equipment?
posted_image

-------------
CQ

Replies:

Posted By: i am an idiot
Date Posted: October 19, 2012 at 9:08 AM

There should be instructions with whatever swc interface you are going to use.

Posted By: shortcircuit161
Date Posted: October 19, 2012 at 9:11 AM

PAC and Axxess Interface (makers of audio integration modules) state the steering wheel controls would use Pins 4 & 5 on Connector 1 (Plug A)

Just like "i am an idiot" said, the instructions for what wire goes to those pins would come with the interface module.

-------------

Posted By: cq358
Date Posted: October 19, 2012 at 12:31 PM

Sorry gentlemen, I should explain what is my project is all about. I am driving a base Vibe without audio control. It is a project to install the steering audio control on a base model head unit. Nobody had done that before. I understand I could go with the SWC route, perhaps I could do that at the future. Therefore I have no access to SWC installation instructions.

I have my new clock spring installed.Control pad ready, Now All I need is to wire properly from steering wheel control pad to the head unit.

I sent a request to Delphi OEM tech support Wednesday for pin diagram. They got back to me this morning and I attached it on this tread as well for future reference. I did poke around in various site and could not find anything. My GM dealer is a brick and not willing to help me out letting me to look at their Mitchell wiring diagram.

-------------
CQ

Posted By: cq358
Date Posted: October 19, 2012 at 12:34 PM

Please note that according to the earlier post. " Plug A" in my diagram is labeled at "B" on the Delphi diagram.

Thanks,

-------------
CQ

Posted By: cq358
Date Posted: October 19, 2012 at 12:50 PM

These are 10 cents Delphi terminal for Micro 64 plugs, even though they are gold plated, dealer in here marked up to 4 dollars each. posted_image

I ended up brought 50 pcs from Mouser Electric. With shipping only cost 13 bucks in total should be here by next week.

-------------
CQ

Posted By: cq358
Date Posted: October 19, 2012 at 3:12 PM

Piece everything together would be like the following.
posted_image

Thanks Shortcircuit161, you are correct.

-------------
CQ

Posted By: pakong
Date Posted: January 26, 2017 at 1:57 PM

Were you able to get the project done? I'm trying to do the exact same thing with a 2010 Pontiac Vibe Base. what is the part number on the clockspring? I already have the steering wheel

-------------
Vibe Runner