Print Page | Close Window

2012 toyota highlander w/push start

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132694
Printed Date: May 04, 2025 at 4:31 AM


Topic: 2012 toyota highlander w/push start

Posted By: gw99
Subject: 2012 toyota highlander w/push start
Date Posted: November 17, 2012 at 11:42 AM

Hello,

I am looking for wiring diagrams for a compustar remote start installation with an idatalink ADS-Blade. I have heard I only need to connect power, etc and that the bypass module will handle everything else.. is this true?



Replies:

Posted By: kreg357
Date Posted: November 17, 2012 at 1:57 PM

You will need a ADS Blade AL flashed with Blade AL(DL) TL1 firmware.  Here is a link to the install guide which shows
all the necessary wiring :  https://www.idatalink.com/support/get-install-guide/guide_id/6781    As shown on the Type 3
diagram, the Compustar's Ignition1 output, with diode, is used.   Below is a notice from the install guide.

IMPORTANT:
1- NO TAKEOVER AVAILABLE.  UPON OPENING VEHICLE DOOR ENGINE WILL SHUTDOWN.
2- ALL DOORS MUST BE CLOSED TO REMOTE START VEHICLE.



-------------
Soldering is fun!


Print Page | Close Window