2012 jeep wrangler unlimited remote start

Looking for R/S wiring.

4 door
6 speed manual

DIRECTWIRE™ WIRING INFORMATION - JEEP / WRANGLER / 2012 / Remote Start

[PRINT THIS PAGE]

12volts      red      +      battery or underhood fuse box
Starter      yellow/gray (for starter kill only)      +      starter or underhood fuse box, blue 26 pin plug, pin 8
Second Starter      PURPLE / brown (use interface mod or Tech Doc 1084)      - 180 ohms      ignition switch, black 5 pin plug, pin 2
Ignition      pink/white      +      ignition switch, black 5 pin plug, pin 3
Second Ignition      N/A           
Third Ignition      N/A           
Accessory      same as second starter      - 560 ohms     
Second Accessory      N/A           
Keysense      same as second starter      -8.5K ohms     
Power Lock      PURPLE / lt. green      -1000 ohms      driver kick, door harness, black 14 pin plug, pin 5
Power Unlock      same as power lock      - 249 ohms     
Lock Motor      tan/white      5 wire      driver kick, door harness, black 14 pin plug, pin 8
Unlock Motor      tan/lt. green      5 wire      driver kick, door harness, black 14 pin plug, pin 1
Parking Lights+      WHITE/ orange (L), WHITE/ purple (R)      +      passenger kick, harness to rear
Parking Lights-      (LIN bus)           
Hazards      WHITE/ dk. blue      -      hazard switch, black 8 pin plug, pin 1
Turn Signal(L)      WHITE/ lt. green (F); WHITE/ dk. green (R)      +      turn signal light (F); passenger kick, harness to rear (R)
Turn Signal(R)      WHITE/ tan (F); WHITE/ yellow (R)      +      turn signal light (F); passenger kick, harness to rear (R)
Reverse Light      WHITE/ gray      +      passenger kick, harness to rear
Door Trigger      purple      -      driver kick, door harness, black 14 pin plug, pin 4
Dome Supervision      yellow/white      +      underdash light or passenger kick, harness to rear
Trunk/Hatch Pin      PURPLE / orange      -      passenger kick, harness to rear
Hood Pin      PURPLE / lt. blue      -      hood switch or underhood fuse box, gray 16 pin plug, pin 3
Trunk/Hatch Release      N/A           
Power Sliding Door      N/A           
Factory Alarm Arm      arms on lock with door open           
Factory Alarm Disarm      see disarm no unlock           
Disarm No Unlock      Sentry Key, ignition, and keysense           
Tachometer      bn/yl, bn/dk bu, bn/lt bu, bn/tn, bn/og, or bn/pu      ac      any fuel injector, black 2 pin plug, pin 2
Wait to start      N/A           
Brake Wire      WHITE/ tan      +      brake switch, gray 6 pin plug, pin 6
Parking Brake      dk. GREEN / WHITE      -      parking brake switch, black 1 pin plug, pin 1
Horn Trigger      gray / YELLOW      +      horn or underhood fuse box, green 26 pin plug, pin 18
Memory Seat 1      N/A           
Memory Seat 2      N/A           
Memory Seat 3      N/A           

Interface Modules: Not Available


      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.


-------------

Parking Brake is the same color as listed behind the cluster. Goto Metraonline.com and look up the directions on how to remove the radio. You don't actually need to remove the radio, but the same panels come off to get to the back of the cluster.
There is 12volt constant at the Passenger kick panel RED / blue, same harness as your rear door pins and Positive parking Lights(WHITE/ Purple). Change your remote starter fuse to 15 amps.
Passenger door pin is hard to get to, there is little slack to get to the wires above the plugs. I unclip it from the hole and the clip harness is tangled up between other harness's. If you untangle it, you get "a little" more slack.
I haven't done a Manual transmission, but the clutch bypass wire is yellow/orange(-) at the Black 3 pin plug, pin 2 at the clutch switch located in the engine bay. It also daid it can be found at the PCM in the engine bay. Connector C3 Pin 22.