Print Page | Close Window

2001 Toyota Avalon XLS Remote Start

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133008
Printed Date: May 04, 2024 at 1:26 PM


Topic: 2001 Toyota Avalon XLS Remote Start

Posted By: 360glitch
Subject: 2001 Toyota Avalon XLS Remote Start
Date Posted: December 18, 2012 at 8:56 AM

Thanks in advance for the help.



Replies:

Posted By: shortcircuit161
Date Posted: December 18, 2012 at 10:00 AM
What help did you need? Your message is vague at best.

-------------




Posted By: 360glitch
Date Posted: December 18, 2012 at 10:22 AM
shortcircuit161 wrote:

What help did you need? Your message is vague at best.

Sorry, I was looking for the wiring chart for this vehicle.




Posted By: shortcircuit161
Date Posted: December 18, 2012 at 10:34 AM

DIRECTWIRE™ WIRING INFORMATION - TOYOTA / AVALON / 2001 / Remote Start

[PRINT THIS PAGE]

12volts      wh/blu (40A), wh/red (10A)      +      ignition harness
Starter      BLACK/ white      +      ignition harness
Second Starter      N/A           
Ignition      BLACK/ orange      +      ignition harness
Second Ignition      WHITE/ red      +      ignition harness
Third Ignition      N/A           
Accessory      WHITE/ green      +      ignition harness
Second Accessory      N/A           
Keysense      RED / yellow      -      ignition harness
Notes: Using the status output wire from the remote start to ground this wire will disarm the alarm without unlocking the doors.
Power Lock      see Tech Doc 1070           
Power Unlock      see power lock           
Lock Motor      blue/red      5wi      right side of the fusebox
Unlock Motor      blue/white      5wi      right side of the fusebox
Parking Lights+      use (-) wire only           
Parking Lights-      pink      -      steering column or BCM
Notes: The BCM (Body Control Module) is attached to the bottom of the fuse box.
Hazards                 
Turn Signal(L)                 
Turn Signal(R)                 
Reverse Light                 
Door Trigger      RED / blue or red      -      right side of the fusebox
Dome Supervision      GREEN/ red      -      driver A pillar
Trunk/Hatch Pin      red      -      left side of the fusebox
Hood Pin      black      -      theft ECU
Notes: The theft module is located above the glovebox.
Trunk/Hatch Release      blue      -      switch on dash
Notes: Only works if main switch in the glove box is on.
Power Sliding Door      N/A           
Factory Alarm Arm      arms with lock           
Factory Alarm Disarm      disarms with unlock           
Disarm No Unlock      use key sense wire           
Tachometer      black      ac      driver kick panel
Notes: Located in a gray plug, with the wires going up to the instrument cluster.
Wait to start      N/A           
Brake Wire      RED / blue or GREEN / WHITE      +      brake switch or pass. kick
Parking Brake                 
Horn Trigger      GREEN/ black      -      steering column
Memory Seat 1                 
Memory Seat 2                 
Memory Seat 3                 

Interface Module:     Category:
Door Lock Interface     Required:
No     Type:
Data Bus
Part #: IM-Toyota-2
Notes:
Interface Module:     Category:
Immobilizer Bypass     Required:
Yes     Type:
Transponder
Part #: 1100X
Alternate Part1 #: DesignTech 29402
Alternate Part2 #: 1100F
Alternate Part3 #: 555XW
Alternate Part4 #: 556UW
Alternate Part5 #: DesignTech 20402
Notes: The synch wire is blue / YELLOW, clock wire is blue/orange, data wire is pink/green, ignition wire is BLACK/ white, and ground wire is WHITE/ black. When using the 1100F, a software change to 1100TL is needed.


      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.


-------------




Posted By: 360glitch
Date Posted: December 18, 2012 at 10:40 AM
Thanks! Just wanted to doublecheck my other source.





Print Page | Close Window