2014 Ford Escape, Alarm/Remote Start

Does anybody have any wiring data on the 2014 Escapes yet? Also, do you know if the bypasses, particularly the Fortin EVO-ALL, has firmware that will work fully with the 2014?
Thank you in advance!

Use a valet key With a relay for by-pass

-------------
Owner of 12 Volt Mobile over 15 year in car electronic

Here is the information for a 2013... not sure if the 2014 is the same or not so test and verify EVERYTHING.

12volts      yellow (50A), red (50A)      +      BCM behind glove box, green 2 pin plug (G), pins 1 and 2
Starter      blue/white      +      ignition switch, black 7 pin plug, pin 7
Second Starter      N/A           
Ignition      BROWN / yellow      +      ignition switch, black 7 pin plug, pin 1
Second Ignition      N/A           
Third Ignition      N/A           
Accessory      PURPLE / green      +      ignition switch, black 7 pin plug, pin 6
Second Accessory      N/A           
Keysense      blue/gray      +      ignition switch, black 7 pin plug, pin 5
Power Lock      gray / YELLOW      -      BCM behind glove box, brown 60 pin plug (B), pin 36
Power Unlock      PURPLE / gray or PURPLE / orange      -      BCM behind glove box, blue 60 pin plug (C), pin 26
Lock Motor      BROWN / white (with one-touch down only power wndw)      5 wire      BCM behind glove box, brown 20 pin plug (E), pin 1
Notes: On vehicles with one-touch up/down power windows, it is PURPLE / green at the Driver Door Module, black 22 pin plug, pin 3.
Unlock Motor      blue/green (with one-touch down only power wndw)      5 wire      BCM behind glove box, brown 20 pin plug (E), pin 10
Notes: On vehicles with one-touch up/down power windows, it is blue/green at the Driver Door Module, black 22 pin plug, pin 4.
Parking Lights+      GREEN/ orange (L), BROWN / yellow (R)      +      BCM behind glove box, green 42 pin plug (A), pins 1 and 26
Parking Lights-      (LIN bus)           
Hazards      BROWN / yellow      -      BCM behind glove box, blue 60 pin plug (C), pin 27
Turn Signal(L)      blue/green (F); gray/orange (R)      +      BCM, green 20 pin plug (D), pin 12; brown 60 pin plug (B), pin 6
Turn Signal(R)      yellow/purple (F); GREEN/ orange (R)      +      BCM, green 42 pin plug (A), pin 22; brown 60 pin plug (B), pin 10
Reverse Light      GREEN/ brown      +      BCM behind glove box, brown 20 pin plug (E), pin 19
Door Trigger      GREEN/ purple      - N.C.      BCM behind glove box, brown 60 pin plug (B), pin 45
Dome Supervision      gray/purple      -      BCM behind glove box, gray 20 pin plug (H), pin 11
Trunk/Hatch Pin      yellow/orange      - N.C.      BCM behind glove box, brown 60 pin plug (B), pin 47
Hood Pin      blue/orange      - N.C.      BCM behind glove box, green 42 pin plug (A), pin 15
Trunk/Hatch Release      brown (rear handle switch)      -      BCM behind glove box, brown 60 pin plug (B), pin 49
Notes: On vehicles with power liftgate, the open/close is gray / YELLOW (-) at the power liftgate switch, 12 pin plug, pin 4.
Power Sliding Door      N/A           
Factory Alarm Arm      arms on lock with door open           
Factory Alarm Disarm      see disarm no unlock           
Disarm No Unlock      Transponder and ignition           
Tachometer      GREEN/ blue, gray/yel, PURPLE / gray, or yellow/org      ac      any fuel injector, black or white 2 pin plug, pin 1
Wait to start      N/A           
Brake Wire      PURPLE / white      +      brake switch or BCM behind glove box, green 42 pin plug (A), pin 16
Parking Brake      WHITE/ purple      -      park brk sw or BCM behind glove box, blue 60 pin plug (C), pin 25
Horn Trigger      PURPLE / green      -      BCM behind glove box, green 42 pin plug (A), pin 31
Memory Seat 1      PURPLE / white      -      driver kick, harness to rear
Memory Seat 2      yellow      -      driver kick, harness to rear
Memory Seat 3      blue/orange      -      driver kick, harness to rear

-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205

Thank You all!

All,
I have finally gotten around to installing a remote start on a 2014 Escape with Ecoboost 1.6L. using a Fortin EVO All. Let me start by saying that the EVO does not do anything other than act as an immobilizer bypass. Tech support confirmed this after a week of troubleshooting. This is very different from the 2013 models. So, I am now disconnecting wires from the Fortin and wiring them directly to the vehicle. The remote start unit is a Python 5706P. I have them mostly figured out except for the tach wire. I am struggling to actually find an injector. I started taking everything off the top of the motor thinking they are underneath the plastic case the plugs are mounted to, but stopped because there must be a better way. Has anybody found the tach wire in one of these vehcles?

Thank you