Print Page | Close Window

02 saturn sc2

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=134700
Printed Date: April 27, 2024 at 10:28 AM


Topic: 02 saturn sc2

Posted By: swojcik
Subject: 02 saturn sc2
Date Posted: August 10, 2013 at 11:59 PM

i would have ask in this thread but the topic was closed.

this information is help full but i wanted some clarification.

do i need both the immobilizer bypass 555lw and the interface module 1700g?

https://www.the12volt.com/installbay/forum_posts.asp?tid=86610#reply



Replies:

Posted By: kreg357
Date Posted: August 11, 2013 at 7:16 PM
You only need one module to bypass the Passlock2.

According to the note at the bottom, either will handle the Passlock2 but neither will handle the door locks. There are other
bypass modules available for that car besides the 555L ( 555LW / 556LW ). A good Data style bypass module is the ADS TBSL PL.

The door locks are Type B (+). You can handle them directly with a 451M door lock module ( $10 ) or via data with a SATDL
module ( $7 ).

A lot of techs feel that the Saturn's Passlock2 is best bypassed with the old relays and resistor method outlined below :
https://techservices.audiovox.com/TechnicalIndex.aspx

One addition note on that car from Bulldog Security below :
NOTE *1 THE LIGHT GREEN(-) KEY SENSE WIRE AT THE STEERING COLUMN MUST SEE A (-) NEGATIVE DURING REMOTE
START TO KEEP THE SERVICE ENGINE LIGHT FROM COMING ON. SPLICE THE BANDED END OF A 1 AMP RECTIFIER
DIODE(1N4004, FROM RADIO SHACK) TO THE NEGATIVE STATUS OUTPUT WIRE(SAME WIRE THAT RUNS TO YOUR BYPASS
MODULE) FROM REMOTE STARTER, TAP UNBANDED END OF DIODE INTO THE KEYSENSE WIRE.

-------------
Soldering is fun!





Print Page | Close Window