2002 Mitsubishi Montero wire diagram
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=14253
Printed Date: April 24, 2024 at 12:20 AM
Topic: 2002 Mitsubishi Montero wire diagram
Posted By: Kanabul
Subject: 2002 Mitsubishi Montero wire diagram
Date Posted: May 31, 2003 at 6:01 PM
Anyone have one? Or know where to find one?
Replies:
Posted By: jayts95
Date Posted: May 31, 2003 at 6:55 PM
ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|white |+ |ignition harness |
| STARTER|blk/yel or blk/blu |+ |ignition harness |
| IGNITION|BLACK/ white |+ |ignition harness |
| ACCESSORY|blue/red |+ |ignition harness |
| SECOND ACCESSORY|blue |+ |ignition harness |
| POWER LOCK|BLACK/ red *1 |- |right rear side of fuse box |
| POWER UNLOCK|BLACK/ blue *1 |- |right rear side of fuse box |
| PARKING LIGHTS +|GREEN / WHITE | |headlight switch |
| HEADLIGHTS|red |- |headlight switch |
| DOOR TRIGGER|GREEN/ red |- |top of fuse box *2 |
| TRUNK/HATCH PIN|tied in with door | | |
| HOOD PIN| | | |
| FCTRY ALARM ARM|blue / YELLOW |- |drivers kick panel |
|FCTRY ALRM DISARM|BLACK/ red |- |drivers kick panel |
| TACHOMETER|wht/blk or white | |coil or ignition module *3 |
| SPEED SENSE|yellow/white | |data link connector *4 |
| BRAKE WIRE|green |+ |brake switch |
| HORN TRIGGER|green |+ |horn or relay underhood |
| WIPERS|blu/red(L),blu/blk(H|+ |steering column |
| LF WINDOW UP/DN|red - green |A |drivers door switch |
| RF WINDOW UP/DN|RED / blu - blk/yel |A |drivers switch or kick panel|
| LR WINDOW UP/DN|RED / wht - grn/wht |A |drivers switch or kick panel|
| RR WINDOW UP/DN|RED / wht - grn/wht |A |drivers switch or kick panel|
| SUN RF OPN/CLOSE|blu/wht - blue |A |motor at front of sunroof |
| RADIO ILLUMINATE|GREEN/ blue |+ |radio |
| POWER ANTENNA|WHITE/ black |+ |radio |
Notes:
NOTE: Some models have an immobilizer system that needs to be bypassed during remote start. Use DEI module 555U to bypass. *1 Warning! When doing door locks on these trucks make sure you DO NOT cycle the door locks rapidly. This may cause the ETACS module to fail and the door locks will no longer work. Also, you MUST add diodes to the lock and unlock output from our units to prevent damage to the ETACS. Make sure you insert the diodes with the cathode (stripe side) towards our unit. *2 In a 2 pin plug. Also found in the drivers A pillar. *3 On the 2.4L, tach is wht/blk at the coil on the left front of the engine compartment. On the 3.0L and 3.5L it is white at the ignition module next to the coils on the right rear side of the engine compartment under the plastic motor cover. *4 The data link connector is under the driver side dash, near the relay box.
Posted By: Kanabul
Date Posted: May 31, 2003 at 8:20 PM
Thank you very much!
Posted By: Kanabul
Date Posted: June 02, 2003 at 7:56 PM
Could anyone explain how to make the damn remote start work on this vehicle? I understand it has an immobilizer, but how do you bypass that?
Posted By: jayts95
Date Posted: June 04, 2003 at 7:21 PM
You need to you a bypass kit. The model number is 555U that is made by a company called DEI. It uses one of your keys to send a signal to your car only during remote start.
|