2010 Ford Ranger XLT Remote Start Wiring

need help finding wiring diagram for 2010 ford ranger xlt thanks adding a remote starter

-------------
dw

RANGER      2007-2011
KEY      T-HARNESS      IMMOBILIZER
FDKEY-4      N/A      FORDS TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1
PART      COLOR      LOCATION      DIAGRAM
12 VOLT CONSTANT      RED (+)      @ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 2      
STARTER      BLUE/WHITE (+)      @ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 5      
STARTER 2      N/A           
IGNITION 1      WHITE/ORANGE (+)      @ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 1      
IGNITION 2      N/A           
IGNITION 3      N/A           
ACCESSORY/HEATER BLOWER 1      BROWN/YELLOW (+)      @ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 8      
ACCESSORY/HEATER BLOWER 2      PURPLE/GREEN (+)      @ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 3      
KEYSENSE      N/A           
PARKING LIGHTS ( - )      N/A           
PARKING LIGHTS ( + )      PURPLE/WHITE (+)      @ HEADLIGHT SWITCH or SJB, BLACK 22-PIN PLUG(D), PIN 5, SEE NOTE #2      
POWER LOCK      GRAY/YELLOW (TYPE B)      IN DRIVERS KICK PANEL or SJB, BLACK 32-PIN PLUG(C), PIN 5, SEE NOTE #2      
POWER UNLOCK      PURPLE/GRAY (TYPE B)      IN DRIVERS KICK PANEL or SJB, BLACK 32-PIN PLUG(C), PIN 9, SEE NOTE #2      
LOCK MOTOR WIRE      GRAY/BROWN (5-WIRE TYPE)      IN DRIVERS KICK      
DOOR TRIGGER      GREEN/PURPLE (-)      IN DRIVERS KICK PANEL or SJB, BLACK 32-PIN PLUG(C), PIN 6, SEE NOTE #2      
DOMELIGHT SUPERVISION      GREEN/BLUE (+)      @ SJB, BLACK 32-PIN PLUG(C), PIN 8, SEE NOTE #2      
TRUNK RELEASE      N/A           
SLIDING POWER DOOR      N/A           
HORN      YELLOW/LT.GREEN ot YELLOW/RED (-)      @ HORN SWITCH or SJB, BLACK 22-PIN PLUG(D), PIN 12, SEE NOTE #2      
TACH      Any wire NOT BROWN/WHITE (AC)      @ ANY FUEL-INJECTOR      
WAIT TO START LIGHT      N/A           
BRAKE      PURPLE/WHITE (+)      @ BRAKE PEDAL SWITCH      
FACTORY ALARM DISARM      N/A           
ANTI-THEFT      FORDS TRANSPONDER ANTI-THEFT, SEE NOTE #1      @ IGNITION SWITCH TUMBLER      
NOTES
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, use # PKALL or PKFM.

NOTE #2: The SJB,(SMART JUCTION BOX) is located in the PASSENGER KICK.

-------------
~wirewise~ Verify all wiring with your meter before making any connections!

thanks for your help

-------------
dw