2017 Jeep Wrangler Base Remote Start
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=144531
Printed Date: May 03, 2024 at 11:46 AM
Topic: 2017 Jeep Wrangler Base Remote Start
Posted By: hardermods
Subject: 2017 Jeep Wrangler Base Remote Start
Date Posted: June 16, 2018 at 8:20 AM
I'm adding power locks and a remote starter to a 17 JKU, I got the actuators all installed and working. The remote start on the other hand, not so much.
I'm using the Avital 4105L with a Fortin EvoRS-chrt5, I was told to connect all the Avital wires to the fortin, when I do that nothing happens. I ran a wire from the starter output under the engine fuse box and now the avital engages and the Jeep will crank, but it never fires up.
Evo Avital
Yellow (Ignition) ---- Pink
Purple (Lock/Arm) ---- Green/White
Purple/White(Unlock/Disarm) ---- Light Green
Green (Door Status)
White (Trunk Status)
Orange (Sliding Door, left)
Orange/Black (sliding Door, right)
Dark Blue (Ground when running) ---- Orange
Red/Blue (Starter) ---- Purple
Light/Blue (Not used)
Black (Brake) ---- Brown
Pink (Tach) ---- Purple/White
Yellow/Black(Trunk Release)
Brown/White (HandBrake) ---- Black/White
Pink/Black (Hood Status) ---- Gray (Also has aftermarket pin switch T-in)
2 power wires on the Avital are ran under the hood to the battery
Avital - Pink/White and Orange are not connected to anything
Avital - Satellite Harness is not connected
Evo - Data Link 4 pin is not connected to anything, the T of the data link, I do have the main data link plugged into the evo. I did the programming on the evo and it seems to have worked.
|