2009 Honda Accord, Remote Start Wiring

Does anyone have a tech sheet on where the parking light and the trunk release wire is on a 2009 Honda Accord 4dr? I tried following the ones this site but no luck. If you have pictures, that’ll be even better.

-------------
4Runner-4life

ACCORD     2009-2012
KEY     T-HARNESS     IMMOBILIZER
N/A     N/A     HONDA'S TRANSPONDER SYSTEM, See NOTE #1
PART     COLOR     LOCATION     DIAGRAM
12 VOLT CONSTANT     WHITE (+)     @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 2     
STARTER     YELLOW (+)     @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 1     
STARTER 2     N/A          
IGNITION 1     BLUE (+)     @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 5     
IGNITION 2     N/A          
IGNITION 3     N/A          
ACCESSORY/HEATER BLOWER 1     ORANGE (+)     @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 3     
ACCESSORY/HEATER BLOWER 2     RED(+)     @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 4     
KEYSENSE     N/A          
PARKING LIGHTS ( - )     GRAY (-)     @ HEADLIGHT SWITCH, (BLACK/WHITE, 12-Pin Plug) Pin 11     
PARKING LIGHTS ( + )     RED (+) (Left Front and Left Rear) Note #2     @ DRIVERS DASH FUSE BOX, (LT. GREEN, 16-Pin Plug) Pin 11     
POWER LOCK     ORANGE (-) TYPE B, SEE NOTE #3     @ POWER WINDOW MASTER SWITCH,(GRAY, 37-Pin Plug) Pin 28     
POWER UNLOCK     BROWN & WHITE (-) TYPE B, SEE NOTE #3 AND #4     @ POWER WINDOW MASTER SWITCH, (GRAY, 37-Pin Plug) Pins 29 and 31     
LOCK MOTOR WIRE     ORANGE (5-wire type)     SEE NOTE #5     
DOOR TRIGGER     BROWN (-)     @ DRIVERS DASH FUSE BOX, (LT.GREEN 16-Pin Plug) Pin 12     
DOMELIGHT SUPERVISION     PINK (-)     Below DRIVERS DASH FUSE BOX, (WHITE, 4-Pin Plu) Pin 2 or WHITE 20-Pin Plug, Pin 12     
TRUNK RELEASE     USE TRUNK RELEASE MOTOR WIRE          
SLIDING POWER DOOR     N/A          
HORN     ORANGE or GREEN/YELLOW (-)     @ HORN SWITCH or DRIVERS DASH FUSE BOX, (LT.GREEN 33-Pin Plug) Pin 23     
TACH     ANY WIRE NOT YELLOW/BLACK (INLINE 4), YELLOW (V6) (AC)     @ Any FUEL-INJECTOR     
WAIT TO START LIGHT     N/A          
BRAKE     LT. GREEN (+)     @ BRAKE SWITCH or DRIVERS DASH FUSE BOX, (LT.GREEN 33-Pin Plug) Pin 2     
FACTORY ALARM DISARM     SEE POWER UNLOCK          
ANTI-THEFT     HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module, See NOTE #1     @ IGNITION SWITCH TUMBLER     
NOTES
NOTE #1: HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. (For Remote Starting/Door Locks) Part # DB-ALL (No Extra Key Required for Operation) 1-KEY Required for Programming.

NOTE #2: the RIGHT FRONT wire is GRAY (+) @ the PASSENGER KICK FUSE BOX, (LT. GREEN, 16-Pin Plug) Pin 11

NOTE #3: TEST these wires while turning the Key in the Drivers Door.

NOTE #4: the BROWN (-) is the DOOR Key Cylinder UNLOCK wire and WHITE(-) is the DOOR UNLOCK Detection wire. Use BOTH wires and Diode Isolate. Program module for Double Pulse Unlock

NOTE #5: on the 2-DOOR, this wire is located in the Drivers Kick Panel. On the 4-DOOR, this wire is located @ DRIVERS DASH FUSE BOX, (GREEN 16-Pin Plug) Pin 9

-------------
~wirewise~ Verify all wiring with your meter before making any connections!

Thanks, I also forgot I had to reverse the polarity for the trunk release.

-------------
4Runner-4life