2007 Chrysler 300, Window Wiring

Hi everyone,
Im looking to put in DEI 535t for the windows in a 2007 chrysler 300.

Would anyone know what the wires are for the 4 windows and where they are?

Most of the wires are on the passenger side of the vehicle, but there is a bunch on the driverside. Im guessing the wires should be there since the driverside does controll 4 windows.

Thanks

Left Front Window (Up/Down)     orange/white - orange/lt. green (base models)     A     power window main switch, lt. gray 8 pin plug, pins 6 and 7     
Right Front Window (Up/Down)     orange/gray - orange/tan (base models)     A     driver kick, door harness          
Left Rear Window (Up/Down)     orange/gray - orange/white     A     driver kick, door harness          
Right Rear Window (Up/Down)     orange/dk. blue - orange/lt. blue     A     driver kick, door harness

-------------
33 years as a installer now just a retired old guy. Favorite thing to install/topic are remote starts/car alarms. Stop using test lights!!!

Thank you!

mgoetz74 wrote:

---

Left Front Window (Up/Down)     orange/white - orange/lt. green (base models)     A     power window main switch, lt. gray 8 pin plug, pins 6 and 7     
Right Front Window (Up/Down)     orange/gray - orange/tan (base models)     A     driver kick, door harness          
Left Rear Window (Up/Down)     orange/gray - orange/white     A     driver kick, door harness          
Right Rear Window (Up/Down)     orange/dk. blue - orange/lt. blue     A     driver kick, door harness

---

So im lost. I cant finds a orange/light green in the grey plug.

Grey plug has 7 wires, front windows has 5 wires and is a black plug.
I can control both front windows with the grey unplugged.

I did find a schematic and the wires you provided are correct.. did it change for the touring?
I have a 2007 300 touring base model. So no sound system. Regular chip key. Not sure if any of that helps or matters.
Will try to post pics of the wires

First is the grey plug wires.
2nd is the black plug wires.

I found this from a 300 forum:

The front windows are Canbus controlled. You can bypass that for the window modules by wiring directly to the motor inputs in the door.

The rears are not Canbus controlled, so you can wire them up under the dash

I followed it..I may have to chage the switch wires to directly to the switches and not the control module. Windows go up when i arm the car, but doesnt work with aux inputs. Plus i cant seem to program the modules. When i ground the red/white wire from the module for programming the windows move down slightly then down all the way. Its says hold the driverside switcb up for a few seconds and the windows should move.. they dont move for me.

The rear windows are wired in the kick panel as per above by Blowndakrt. But seems the switches in each door stopped working. I can only use the windows from the master switch.

Any ideas? Do i need to wire earch rear door as well?

Is there anyway to bypass the master switch front auto up?

Ive wired the 535 direct to the motors in the door.

They need to show constant power when i hold the button up to get into programming mode.

When i hold the switch, power to the motor is only 1 second both up and down.

I tried to cut the switch wire at the 5 pin harness under the switch and hook that up directly to the 535 switch input.. but does nothing.

I beleive it was the tan/orange that when gounded puts the window up. I tried to just ground the wire to put the 535 in programming mode as it showed constant power.. but that also didnt work.

Not sure how to bypass the auto up/down