Please help, looking to wire a amp to factory pioneer 6 disc in dash. Anyone have the wiring diagram? Need to convert to rca output. I already have the 4 channel converter. Thanks, Dan
-------------
2002 Explorer Sport,ppi ax606.2,(3)JL 10w6,mb quart mids,factory 6 disc in dash
There should be three different plugs....one of them is more rectangular than the others. This plug has all the wires you need:
Pin #5: RR+
Pin #6: RR-
Pin #7: RF+
Pin #8: RF-
Pin #10: +12 volts switched
Pin #12: LR+
Pin #13: LR-
Pin #14: LF+
Pin #15: LF-
This picture might help you a little bit (Ford harness that would plug in to the plugs you have in your vehicle right now). The one that has all your connections looks like it would plug in to the connector that's in the center of that photo. Also, you can see the green, purple, white, and grey wires coming out of the corresponding pins.
Also this might work but it's basically the same info I just gave you, but here it is nonetheless. Sorry I don't know the factory wire colors but since you're keeping the factory in-dash unit you'll be retaining the oem plugs and this should be enough info to help you figure out the wires.
Just make sure you use a DMM and speaker popper to verify all of the wires first before making your connections.
-------------
Ethan
-----
"Patience, persistence, and perspiration make an unbeatable combination for success"
Donate to the12volt.com Thanks, Ethan I'll try it soon. You are a life saver.
-------------
2002 Explorer Sport,ppi ax606.2,(3)JL 10w6,mb quart mids,factory 6 disc in dash