I am building a k-9 police vehicle and cannot find a VSS lead with enough voltage to shut off th bail out circuit when the vehicle is moving. I tried the green lead at pin K of thre cruise, as well as several other points in the car. I can't just hook this circuit up with ignition because the poilce will sit at idle and release the dog from the car. To clarify, there is a remote tstart system to keep the dog cool, and a door release to let the dog out one door. it unlocks then releases the door and a strut pushes the door open. I do not want the door to open when the vehicle is moving. This could injur a very expensive dog.
-------------
17 years in the 12 volt industry MECP 1st Class
if you have a 3.1 or 3.4 sfi engine check plug on trans. passenger side the color is yellow and blue. this is the vss lift the car is easy to view plug
I used this wire firstr, but it seems to be to low a voltage to activate the necessary circut, I am currently building a prototype circuit that will take this low AC voltage and trigger a low current 12 volt dc relay, If anyone has the rocket science to help me with this task I would sure appreciate any input. I believe I am getting about 1.2 to 1.4 volts AC off this VSS lead, I am thinking diode then capacitor to rectify to DC, then an IC type (solid state) relay which will trigger off 1.125 volts DC. What do you think?
-------------
17 years in the 12 volt industry MECP 1st Class
Does this help Philo ??:
02 CHEVROLET IMPALA
Control Lever: 250-3421,250-1483(RF)
Adapter: N/A
VSS Wire: LOCATION 15- AIR FILTER BOX YELLOW 80 PIN CONNECTOR OF ECM POSITION 55
VSS Wire Color: GREEN OR GREEN / WHITE
VSS Pulse: 4000
VSS Tach Wire: LOCATION 15- AIR FILTER BOX YELLOW 80 PIN CONNECTOR POSITTION 54
Tach Signal Wire Color: WHITE
Brake Switch Positive: ORANGE
Brake Switch Negative: WHITE
https://www.rostra.com/pdf/wirelocations.pdf
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA