2004 Wrangler Alarm Info

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28656
Printed Date: May 07, 2025 at 3:05 PM

Topic: 2004 Wrangler Alarm Info

Posted By: 04Sahara
Subject: 2004 Wrangler Alarm Info
Date Posted: March 19, 2004 at 10:46 AM

I'm installing a Clifford RSX 3.5 into a 2004 Wrangler Sahara with Sentry Key. Customer doesn't want auto-start at this time.

I need to know where the dome light/supervision wire is on the Jeep. 2003 info states to use the door trigger but I'm not too sure about that:

https://www.the12volt.com/installbay/forum_posts.asp?tid=15104&KW=wrangler

Customer also wants 524N (power door locks) and 508D (perimeter sensor) - any hints on placement? Customer either uses either soft top, no top, and doors off. Does not care about perimeter sensor when doors and hard top are on.

I searched and only found 2003 information and some of the wires seem to be a different color.

Replies:

Posted By: jfk51502003
Date Posted: March 26, 2004 at 4:23 PM

12volts	pink/black & red	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter	N/A
Ignition	blue	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	BLACK/ orange	+	ignition harness
Second Accessory	BLACK/ green	+	ignition harness
Keysense
Power Lock
Power Unlock
Lock Motor
Unlock Motor
Parking Lights+	BLACK / YELLOW	+	headlight switch
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	yellow	-	headlight switch
Dome Supervision	use door trigger
Trunk/Hatch Pin
Hood Pin
Trunk/Hatch Release
Power Sliding Door	N/A
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	gray	ac	ignition coil or coil pack
Wait to start	N/A
Brake Wire	WHITE/ tan	+	brake pedal switch
Parking Brake
Horn Trigger	RED / yellow	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Posted By: rudbwoy69camaro
Date Posted: March 27, 2004 at 12:17 PM

Well, seems that "jfk51502003" posted the wiring for a 2003....

-------------

Posted By: pat231
Date Posted: May 14, 2004 at 10:04 AM

Battery 1 Pink/Black Ignition Harness Positive
Ignition 1 Blue Ignition Harness Positive
Starter 1 Yellow (2) Ignition Harness Positive
Accessory 1 BLACK/ Orange Ignition Harness Positive
Parklight Positive BLACK / YELLOW At Parking Light Switch Harness Positive
Brakes WHITE/ Tan At Parking Light Switch Harness Positive
Horn RED / Yellow At Sterring Collumn Negative
Tach Blue/Tan At ECM Passenger side Firewall Set 2 Cyl
E-Brake Gray/Black (5) Black Conn. Behind Instrument Cluster Negative
Clutch Bypass Yellow/Red At Clutch Switch Harness (3) Positive
OEM Hood Switch (1) At Hood Light Bulb Negative
F.L. Door Pin Tan Black Conn. Behind Instrument Cluster Negative
F.R. Door Pin Tan / YELLOW Black Conn. Behind Instrument Cluster Negative
Rear Deffoger Blue/White (4) Black Conn. Behind Instrument Cluster Negative
Head Light PURPLE / White At Parking Light Switch Harness Positive
Wiper Protection Pink/Black (6) At Wiper Switch Connector CUT
Back Up Light PURPLE / Black Driver's Kick Panel Positive
Comments :
Note:This vehicle may be equiped with a passive anti-theft system that uses a transponder use a OM-Chrysler-1 (P/N 310-907-514).
(1) You can solder a wire to the mercury switch under hood light assembly, it throws
a ground when the hood is opened and the light comes on.
(2) Starter Wire Yellow. For manuel remote starter installation connect the starter wire at the Yellow/Red at the clutch switch
(3) Connect the Remote Starter Wire directly on the Yellow/Red , for your " Clutch Bypass " instead of at the Ignition Switch.
(4) Rear Defrost Wire Blue/White. Need a 1 second negative pulse to trig it ON
(5) The E-Brake wire is Gray/Black at the E-Brake Switch, but it's Gray/White at the Cluster connector (See Picture)
(6) Wiper Cut Wire Pink/Black If the Wiper can operate durring the remote starter run time, use a relay to cut this wire with pin 30 and 87a and
one output program for << Ground While Running >>
Jeep Wrangler 2004