Can anyone help me I need the wiring diagram to install an alarm and remote start for a 2004 Chevy Malibu MAXX
| MALIBU 2004 |
| WIRE | COLORS | LOCATION |
| 12 VOLTS CONSTANT | BATTERY | IN THE LEFT SIDE OF THE ENGINE COMPARTMENT |
| IGNITION 1 | PINK | IGNITION HARNESS |
| ACCESSORY /HEATER BLOWER 1 | BROWN | IGNITION HARNESS |
| STARTER | WHITE | IGNITION HARNESS CALL TECH SUPPORT |
| PARKING LIGHTS ( - ) | BROWN / WHITE | AT THE LIGHT SWITCH |
| DOMELIGHT | GRAY ( - ) | AT THE BCM, PLUG C3 PIN A10 ( *1 ) |
| DOOR TRIGGER | ( *2 ) | ( *2 ) |
| POWER DOOR LOCK | WHITE | AT THE BCM, PLUG C1 PIN 66 ( *1 ) |
| POWER DOOR UNLOCK | SAME WIRE AS LOCK | AT THE BCM, PLUG C1 PIN 66 ( *1 ) |
| TACH SENSOR | ( *3 ) | ( *3 ) |
BRAKE | WHITE ( + ) | AT THE BCM, PLUG C1 PIN 24 ( *1 ) |
| TRUNK RELEASE | BROWN / WHITE ( - ) | AT THE BCM, PLUG C1 PIN 71 ( *1 ) |
| TRUNK TRIGGER | ORANGE / BLACK ( - ) | AT THE BCM, PLUG C1 PIN 18 ( *1 ) |
| HOOD TRIGGER | PINK/BLACK ( - ) | AT THE BCM, PLUG C1 PIN 69 ( *1 ) |
| HORN | TAN ( - ) | AT THE BCM, PLUG C2 PIN 14 ( *1 ) |
| ALARM DISARM | FACTORY REMOTE ONLY | N/A |
FACTORY ANTI-THEFT | TYPE | PASSKEY 3 |
NOTES:
*1 - THE BODY CONTROL MODULE ( BCM ) IS PART OF THE FUSE/ RELAY BOX ON THE FRONT PASSENGER SIDE OF THE CENTER CONSOLE. THE BCM HAS FOUR PLUGS C1,C2,C3 AND C4.
*2 - THE CAR HAS FOUR DOOR TRIGGERS. THE DOOR TRIGGER ARE, DRIVERS DOOR GRAY/BLACK ( - ), PASSENGER DOOR TAN/WHITE ( - ), LEFT REAR DOOR LT. BLUE/BLACK ( - ) AND THE RIGHT REAR DOOR LT. GREEN/ BLACK ( - ). USE ALL FOUR AND DIODE ISOLATE EACH.
*3 - THE TACH WIRE ON A 2.2L IS A WHITE OR ORANGE AND ON A 3.5L IS A PURPLE OR ORANGE / WHITE AT THE IGNITION CONTROL MODULE.
Hello Boomer_106,
Do you have the info as you posted above for Clifford RS 3.5 install for Honda Accord 2003. I had trouble with trunk release and trigger which was not in the install manual.
Please advice,
Vince