I am looking for a wiring diagram for an '03 ford mustang convertible, 3.8 V6. I want to hook up a viper 791 XV alarm. PLEASE HELP!!!!!!!!!!!!!!!!!!!!!!!!!
Make: Ford
Model: Mustang
Year: 2002-04
Alarm
Constant 12 volts YELLOW (3) GRN/VIO (2) IGNITION SWITCH HARNESS
Ignition 12 volts RED / LIGHT GREEN IGNITION SWITCH HARNESS
Starter WHITE/ PINK IGNITION SWITCH HARNESS
Dome Light YEL/BLK(DR) GY/RD(PS) AT GEM MODULE * SEE TECH NOTES **
Trunk Pin Switch BROWN / WHITE (-) AT LIGHT IN TRUNK OR GEM MODULE *
Parking Lamp BROWN (+) AT HEADLIGHT SWITCH OR GEM MODULE *
Power Lock LIGHT GREEN PIN 20 OF A BK 20 PIN CONN AT *
Power Unlock VIOLET PIN 18 OF A BK 20 PIN CONN AT * #202
* Generic Electronic Module Is Located Behind Driver Dash Above Brake Pedal. #202 - See Positive Pulse Door Lock Diagram.
Remote Start
Tach Signal ORANGE / YELLOW AT POWERTRAIN CONTROL MODULE * #239
Ignition #2 GRAY / YELLOW (2) IGNITION SWITCH HARNESS **
Ignition #3 RED / BLACK IGNITION SWITCH HARNESS #235
Accessory BLACK/ LT GREEN IGNITION SWITCH HARNESS ***
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light RED / L GREEN (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Light BLACK/ PINK (+) AT SWITCH ON TRANSMISSION
Rear Window Defrost BLACK / YELLOW (+) AT REAR WINDOW DEFOGGER SWITCH
* Powertrain Control Module Is Located In Passenger Kick Panel. ** Two GRAY / YELLOW Wires Present At The Ignition Switch Are The Same Circuit. #235 - See Powering Additional Ignitions Diagram. #239 - See Immobilizer By-Pass Diagram. *** Refer To TECH NOTES For Additional Information On Ignition Switch Layout. OEM Keyless Ign. Interrupt: Not possible
Ignition Switch Layout: Ignition #1 - RED / LIGHT GREEN.......Powers PCM (Primary Ignition). Ignition #2 - GRAY / YELLOW (2).......Powers Blower Motor. * Ignition #3 - RED / BLACK.............Powers Airbag Monitor. Ignition #4 - BLACK/ L GREEN.........Powers Heat/Ac Controls. * Two GRAY / YELLOW Wires Present At The Ignition Switch Are The Same Circuit. **Dome Light:Ford's G.E.M. Will Drop A Low Signal Across The Dome Light And In Most Cases Cause A False Trigger. To Eliminate This Cut the Door Pin Trigger Wires At The G.E.M. And Insert A One-Amp Diode With Band Side Facing Doors.Make Your Isolated Connection On The Door Pin Side. The GEM (Generic Electronic Module) Is Behind The Dash Above The Brake Pedal.
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt