Hi there~
Can anyone help me locate a wiring diagram for a 2000 Dodge Ram 2500 pick up? Manual trans. I truely appreciate it. I'm new here. You guys are a Godsend. Thanks!
Christine
| 12V|red and pink/black |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|dk. blue |+ |ignition harness |
| SECOND IGNITION|BLACK/ orange |+ |ignition harness |
| ACCESSORY|BLACK/ white |+ |ignition harness |
| POWER LOCK|ORANGE / purple *1 |5wi|in harness from |
| POWER UNLOCK|pink/purple *1 |5wi|drivers door |
| PARKING LIGHTS +|BLACK / YELLOW | |drivers kick panel |
| HEADLIGHTS|lt. green *5 |- |steering column |
| DOOR TRIGGER|yellow *2 |- |drivers kick panel |
| FCTRY ALARM ARM| | | |
|FCTRY ALRM DISARM|lt. GREEN/ orange |*3 |harness from door |
| TACHOMETER|BLACK/ gray *4 | |ignition coil |
| BRAKE WIRE|WHITE/ tan |+ |at brake pedal switch |
| HORN TRIGGER|BLACK/ red |- |steering column |
| WIPERS|RED / blk & RED / yel |+ |steering column |
| LF WINDOW UP/DN|lt. blue - white |A |drivers window switch |
| RF WINDOW UP/DN|brn/wht - pur/wht |A |harness from door |
Notes:
Note : Diesel glow plug wire is a ORANGE / black(-) "see directfax document #1090", and the tach wire is a gray/black. Both wires are located on the center of the firewall. There are two black plugs, the wires are in the plug without the white insert. If using the org/blk for wait to start causes a shifting or cruise control problem then use a pulse timer relay instead, refer to directfax #1091 for wiring information. *1 Keyless models use positive trigger for lock, and 5-wire for unlock. Can also find wires at the central timer module to the right side of the steering column, lock is ORANGE / green, unlock is pink/green. *2 To avoid dome delay, use tan for the drivers door and BLACK/ lt. blue for the passenger door. Both wires are located at the central timer module to the right side of the steering column. Use both wires and diode isolate each. *3 Factory disarm is a negative trigger through a 1.5K (1500) ohm resistor. *4 Diesel tach wire is gray/black at the ECM on the passenger side firewall in connector C-1, pin 8 *5 This wire requires a high current negative, must use relay.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA