Printer Friendly Forum Posts - 2004 Saturn Vue alarm/starter wiring

I have:

VUE 2002-2004
WIRE	COLORS	LOCATION
12 VOLTS CONSTANT	ORANGE	IGNITION SWITCH HARNESS
IGNITION 1	PINK	IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER	ORANGE	IGNITION SWITCH HARNESS
STARTER	YELLOW	IGNITION SWITCH HARNESS
PARKING LIGHTS ( + )	BROWN	GRAY 24 PIN PLUG @ BCM PIN B10 SEE NOTES BELOW 1
DOMELIGHT	GRAY/BLACK (L) AND BLACK/ WHITE (R)	GRAY 24 PIN PLUG @ BCM SEE NOTES BELOW 2
POWER DOOR LOCK	RED / BLACK ( + )	GRAY 16 PIN PLUG @ BCM PIN A8 SEE NOTES BELOW 1
POWER DOOR UNLOCK	ORANGE / BLACK ( + )	GRAY 16 PIN PLUG @ BCM PIN A7 SEE NOTES BELOW 3 (TYPE A)
TRUNK RELEASE	N/A
TACH SENSOR	NOT PINK OR BLACK/ WHITE (AC)	AT IGNITION COIL PACK
BRAKE	LT. BLUE ( + )	SWITCH ABOVE BRAKE PEDAL
HORN	BLACK ( - )	PINK 24 PIN PLUG @ BCM
FACTORY DISARM	DISARMS WITH REMOTE ONLY	SEE NOTES BELOW 4
FACTORY ANTI-THEFT	PASSLOCK 2	791 REQUIRED

NOTES:

*1 - The BCM (Body Control Module) is in the center of the dash behind the pocket.

*2 - The driver door trigger is gray/black in pin B2. The passenger door trigger is BLACK/ white in pin A12. Use both wires and diode isolate each.

*3 - To unlock just the driver door use a lt. green (+) wire in pin A2, gray 16 pin plug @ BCM.

*4 - The factory alarm is programmable for Active, Passive (5 minute delay), or Disabled. Turn ignition on, press PANIC button 8 to 10 times in 5 seconds. Within 3 seconds press UNLOCK button for Disabled, LOCK button for Active, or LOCK button twice for Passive.

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.