Do any have the vehicle wiring diagram for the 2002 Toyota Camry..
Remote Starter Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Start: | | | BLACK/ WHITE & BLACK / YELLOW | IGNITION SWITCH HARNESS ** |
Ignition #1: | | | BLACK/ RED | IGNITION SWITCH HARNESS |
Ignition #2: | | | BLACK / YELLOW | IGNITION SWITCH HARNESS ** |
Ignition #3: | | | N/A | |
Accessory: | | | BLUE/RED | IGNITION SWITCH HARNESS |
Brake Light: | | | GREEN / WHITE | AT SWITCH ABOVE BRAKE PEDAL OR FUSE BOX |
Tach Signal: | | | | |
Parking Lights: | | | GREEN (+) | AT DIMMER SWITCH OR NEAR FUSE BOX |
Headlights: | | | RED / YELLOW (-) | STEERING COLUMN HARNESS *** |
OEM Alarm Disarm: | | | DISARMS WITH UNLOCK | |
OEM Alarm Arm: | | | ARMS WITH LOCK | |
Diesel Glow Plug: | | | N/A | |
Clutch Bypass Wire: | | | N/A | |
Notes: | | * This Vehicle Is Equipped With A Transponder Type Anti-Theft System. ** This Vehicle Is Equipped With Two Start Wires. Both Must Be Powered In Order For Vehicle To Start When Engine Is Cold; |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | DTI Color | Vehicle Color | Location |
Constant +12 Volts: | | | WHITE | IGNITION SWITCH HARNESS |
Starter Kill: | | | BLACK/ WHITE & BLACK / YELLOW | IGNITION SWITCH HARNESS *; ** |
Ignition +12 Volts: | | | BLACK/ RED | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | | RED / BLACK (-) | AT BODY CONTROL MODULE HIGH IN DRIVER'S KICK |
OEM Horn: | | | GREEN/ BLACK (-) | STEERING COLUMN HARNESS |
Power Lock: | | | LT. GREEN (-) | IN A GRAY 13-PIN CONNECTOR IN DRIVER'S KICK **** |
Power Unlock: | | | GREEN/ RED (-) | IN A GRAY 13-PIN CONNECTOR IN DRIVER'S KICK **** |
Trunk Release: | | | WHITE/ BLUE (5-WIRE) | IN A 12-PIN CONNECTOR IN DRIVER'S KICK PANEL |
Alarm Input Wire: | | | RED / BLACK (-) | AT BODY CONTROL MODULE HIGH IN DRIVER'S KICK |
Notes: | | *** Test With A Meter First To Verify Correct Wire. Wire Will Measure Ground (-) When Headlights Are Switched On. **** Child Safety Wire is LT. GREEN (-) In A 20 Pin Connector In Driver's Kick Panel. This vehicle has Child Safety Door Lock Diagram. |
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Do you have the color code for the tach signal wire....
Must I use two relays for the starter interrupt circuit being that this vehicle has to starter wires.
Not sure about the tach wire on this car, but I you will only need one relay for the starter interrupt circuit.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Hi Scott105, the tach wire is BLACK/ Orange, Pin #5 in a 31 Pin connector at the ECM.
the12volt
Thanks 12volt for the info... I didn't have this for Scott
. I will update my notes for this vehicle.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA