I am installing a DEI 369D remote starter on a 2003 Camry LE and am having trouble finding the factory neutral safety wire. can someon help? Also, I have found general information on wiring additional relays, but would like more specifcs on the second starter wire & trunk release. Thank You.
Second start is @ the clutch on a manual. BLK/WHT (POS+) This is the way Astroflex does it
The trunk release is BIG blue/white (5 wire) drivers kick. You must rigger the trunk "key sence" wire at the same time as the trunk wire. Use a relay pin 86 and 87 get fused 12V 85 gets your trunk release wire from the brain.
87a gets the dash side of the trunk wire, 30 gets the trunk side of your trunk wire. BEFORE THE RELAY tap your release wire with a diode in line , take it to the trunk key sence wire...its just below the release wire in the kick. Its GRN/WHT. When you hit the trunk pop button on your remote the factory alarm will think your using the key, no need to disarm before!
-------------
Please bare with me, I'm new at this. The car is an automatic with no factory alarm or anti-theft. The wire I'm looking for is the neutral or park safety wire from the gearshift needed to disengage the starter when the car is in gear. Also, the Rattler brain has a positive starter signal which gives direct current to the main factory start wire. On the brain, there is a light guage ribbon harness with a wire tagged "starter relay trigger" but I'm not sure of the polarity. Is this what I need to use for the second starter wire relay? Also, for the trunk release, do I still need to use the diode?