Hi everyone,
I'm trying to fit a keyless entry in my Lex as original remote is missing. Can anyone tell me what wires i need to tap into and where they are located?
Where exactly is the drivers kick panel we dont use this term here in the UK. And also are the locations the same in RHD vehicles?
Thank you for your help.
Regards,
Sai
-------------
saiful
Sai,
"Where exactly is the drivers kick panel we dont use this term here in the UK. And also are the locations the same in RHD vehicles?"
Drivers kick panel just refers to the plastic covering (or panel) close or near to the foot pedal.
The Power Lock wire you are looking for is RED / white, negative polarity in a blue plug.
Power Unlock wire is BLACK/ white, negative polarity also in the same blue plug.
DIRECTWIRE™ WIRING INFORMATION - LEXUS / GS 300 (UK) / 1994 / Keyless Entry
12volts
Starter BROWN / red ignition harness
Ignition BROWN / white ignition harness
Power Lock RED / white - driver kick panel blu plug
Power Unlock BLACK/ white - driver kick panel blu plug
Lock Motor
Unlock Motor
Parking Lights+
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger RED / green - underdash light
Dome Supervision
Trunk/Hatch Release WHITE/ green - at the switch
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Horn Trigger
Memory Seat 1
Memory Seat 2
Memory Seat 3
Immobilizer Bypass Module: Not Available
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
