Hi, I am installing a starter disable on a 2002 beetle. so, I want to know if someone could help me with the wiring diagram for this car.
I would appreciate if anyone could help me.
Thank you
Guss
DIRECTWIRE™ WIRING INFORMATION - VOLKSWAGEN / BEETLE / 2002 / Remote Start
12volts red + ignition harness
Starter RED / black + ignition harness
Second Starter
Ignition black + ignition harness
Second Ignition
Third Ignition
Accessory BLACK/ red + ignition harness
Second Accessory
Keysense
Power Lock yellow/lt.blue - inside drivers door
Power Unlock WHITE/ green - inside drivers door
Notes: Requires double pulse.
Lock Motor blue / YELLOW inside drivers door
Unlock Motor purple / YELLOW inside drivers door
Parking Lights+ gray/purple headlight switch, pin 6
Notes: There are three gray/purple wires at the headlight switch, be sure to use the one that is in pin 6 to keep the dash lights fuse from blowing.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger BROWN / yellow - theft module
Notes: The theft module is located to the left of the steering column.
Dome Supervision same as door trigger
Trunk/Hatch Pin BROWN / black - theft module
Notes: The theft module is located to the left of the steering column.
Hood Pin BROWN / red - theft module
Notes: The theft module is located to the left of the steering column.
Trunk/Hatch Release theft module
Notes: Use BROWN / purple negative trigger on models with power windows, or RED / blue 5-wire positive on models without power windows. The fuel door can be released with a positive trigger on blue/red at the release switch.
The theft module is located to the left of the steering column.
Power Sliding Door
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock
Tachometer GREEN/ YELLOW ignition coil
Wait to start
Brake Wire RED / black + brake switch
Parking Brake
Horn Trigger BLACK / YELLOW + theft module
Notes: The theft module is located to the left of the steering column.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 556U, 555B or 555U
Notes: See DirectFax document 1056 for additional wiring information.
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
