Print Page | Close Window

peugeot 106 genaral wiring

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57523
Printed Date: April 26, 2024 at 2:16 AM


Topic: peugeot 106 genaral wiring

Posted By: joe_1
Subject: peugeot 106 genaral wiring
Date Posted: June 12, 2005 at 3:37 AM

i am after a wiring diagram for this car, if a full one is not possible i need as much as possible thanks in advance.



Replies:

Posted By: joe_1
Date Posted: June 12, 2005 at 3:40 AM
sorry the year of the car is 1997 - 1998




Posted By: thepencil
Date Posted: June 13, 2005 at 11:47 AM


DIRECTWIRE™ WIRING INFORMATION - PEUGEOT / 106 (UK) / 1998 / Remote Start



12volts          
Starter blue      ignition harness
Second Starter          
Ignition orange      ignition harness
Second Ignition blue / YELLOW      ignition harness
Third Ignition          
Accessory yellow      ignition harness
Second Accessory          
Keysense       
Power Lock brown pin 7    -   C/L unit behind glovebox
Power Unlock grey pin 5    -   C/L unit behind glovebox
Lock Motor          
Unlock Motor          
Parking Lights+ red(2333) & grn(2343     n/side kickpanel
Parking Lights-       
Hazards       
Turn Signal(L)       
Turn Signal(R)       
Reverse Light       
Door Trigger red or violet    -   pin switch or interior light
Dome Supervision          
Trunk/Hatch Pin beige      n/side kickpanel
Hood Pin          
Trunk/Hatch Release          
Power Sliding Door       
Factory Alarm Arm          
Factory Alarm Disarm          
Disarm No Unlock          
Tachometer          
Wait to start       
Brake Wire          
Parking Brake       
Horn Trigger          
Memory Seat 1       
Memory Seat 2       
Memory Seat 3       
Interface Modules: Not Available



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image




Posted By: joe_1
Date Posted: June 14, 2005 at 3:23 PM
thanks for the info much apriciated





Print Page | Close Window