Print Page | Close Window

2000 Mits. Mont. Sprt. 4dr

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=58565
Printed Date: May 12, 2025 at 8:32 AM


Topic: 2000 Mits. Mont. Sprt. 4dr

Posted By: gadamon
Subject: 2000 Mits. Mont. Sprt. 4dr
Date Posted: June 29, 2005 at 1:19 PM

I have just installed a new 44-PW530 pwr antenna in my Mits.  When I removed the old antenna, it had a 2 wire connector on it. When installed the new ant. it had 2 wires, one red (with fuse) constant +12v, and one blue switched leg. I put my 12v test light on the 2 wire in harness plug and found one wire "hot" when radio first powered on, then goes dead, and the other wire is hot when radio shut off, then goes dead after delay.  I can only assume old power antenna needed 1 hot to raise ant, and 1 hot to lower ant.

I tried finding a constant hot from the switched side of the radio in the harness, but cannot find any other than the speaker wires.

Can anyone give me some ideas on how I can resolve this issue, without having to go to a solid mast antenna?



-------------
Thanks,
GAD3



Replies:

Posted By: Chad7n7
Date Posted: July 01, 2005 at 8:59 PM
This ought to help you out.

-------------


Print Page | Close Window