92 Park Ave alarm wiring
Printed From: the12volt.comForum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60370
Printed Date: May 08, 2025 at 11:08 AM
Topic: 92 Park Ave alarm wiring
Posted By: jeffbayne
Subject: 92 Park Ave alarm wiring
Date Posted: July 30, 2005 at 1:01 PM
Replies:
Posted By: thepencil
Date Posted: August 02, 2005 at 9:40 AM
DIRECTWIRE™ WIRING INFORMATION - BUICK / PARK AVENUE / 1992 / Security
12volts red + ignition harness
Starter yellow + ignition harness
Ignition pink + ignition harness
Power Lock lt. blue + either kick panel
Power Unlock black + either kick panel
Lock Motor gray drivers door harness
Unlock Motor BLACK/ lt. green drivers door harness
Disarm Defeat tan passengers door harness
Parking Lights+ brown low in drivers kick
Notes: Also found at the lighting control module. The lighting control module is located to the left of steering column.
Parking Lights- dk. blue light switch
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger white - under dash light
Dome Supervision use door trigger
Trunk/Hatch Pin black - at switch or light
Notes: Not available on all models.
Hood Pin
Trunk/Hatch Release lt. blue or blk/wht + at release switch
Power Sliding Door
Factory Alarm Arm yellow - drivers door harness
Notes: Not available on all models.
Factory Alarm Disarm lt. green - drivers door harness
Disarm No Unlock
Tachometer PURPLE / white AC ignition module
Notes: May also be found white at the instrument cluster on models with a tachometer.
Horn Trigger black - steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
VATS
Part #: 652T resistor pack
Notes: See DirectFax document 1049 for interface information.
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
Posted By: jeffbayne
Date Posted: August 02, 2005 at 6:10 PM
Posted By: thepencil
Date Posted: August 03, 2005 at 8:25 AM
You are welcome.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
-------------
Be careful whose advice you buy, but be patient with those who supply it.