Print Page | Close Window

2005 Mazda 6 VSS

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60700
Printed Date: April 26, 2024 at 9:23 PM


Topic: 2005 Mazda 6 VSS

Posted By: rikanman
Subject: 2005 Mazda 6 VSS
Date Posted: August 04, 2005 at 5:58 PM

Looking for Speed signal wire for this car, Im installing a Pioneer navi system on it, any help appreciated, thanks.



Replies:

Posted By: thepencil
Date Posted: August 08, 2005 at 8:25 AM


DIRECTWIRE™ WIRING INFORMATION - MAZDA / 6 / 2005 / Accessory


12volts black (40A), BLACK/ yel (30A)   +   ignition harness
Ignition blue   +   ignition harness
Parking Lights+ lt. GREEN/ black   +   driver kick, 14 pin plug
Parking Lights- RED / white   -   headlight switch
Headlight blue/green   -   headlight switch
Trunk/Hatch Release yellow   -   switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding Door N/A       
Speed Sense GREEN/ red      radio harness
Wipers gray (L), yellow/red (H)   +   windshield wiper switch
LF Window up/dn red - green   A   driver window switch in door
RF Window up/dn GREEN / WHITE - lt. GREEN/ black   A   driver kick, door harness
LR Window up/dn RED / yellow - yellow   A   driver kick, door harness
RR Window up/dn RED / white - brown   A   driver kick, door harness
Sun Roof open/close        sunroof motor
Sun Roof Limit/close N/A       
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: 555U
Notes: Standard on all models.
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Multiplex
Part #: 456LW
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image




Posted By: rikanman
Date Posted: August 08, 2005 at 3:32 PM
Thanks for the info!





Print Page | Close Window