2005 G35 coupe VSS
Printed From: the12volt.comForum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=61509
Printed Date: May 02, 2025 at 6:46 AM
Topic: 2005 G35 coupe VSS
Posted By: corruption2k
Subject: 2005 G35 coupe VSS
Date Posted: August 17, 2005 at 11:17 AM
Replies:
Posted By: thepencil
Date Posted: August 17, 2005 at 12:57 PM
DIRECTWIRE™ WIRING INFORMATION - INFINITI / G35 COUPE / 2005 / Accessory
12volts WHITE/ blue (40A) + ignition harness
Ignition BLACK/ red + ignition harness
Parking Lights+ RED / blue + driver kick, harness to rear
Parking Lights- N/A
Headlight RED / black (L), red (R) + lights or IPDM E/R, gray 16 pin plug
Notes: The IPDM E/R (Intelligent Power Distribution Module Engine Room) is between the passenger fender and the battery.
Trunk/Hatch Release pink - BCM, pin 30
Notes: The BCM (Body Control Module) is in the driver kick panel.
The trunk release motor wire is GREEN / WHITE (+) at the BCM, pin 68.
Power Sliding Door N/A
Speed Sense WHITE/ green 2P radio harness
Wipers purple (L), blue/black (H) + motor or IPDM E/R, gray 16 pin plug
Notes: The IPDM E/R (Intelligent Power Distribution Module Engine Room) is between the passenger fender and the battery.
LF Window up/dn see notes
Notes: Extended triggers on the power lock/unlock wires will roll the windows up/down. Use validity channels to control.
RF Window up/dn see LF window up/dn notes
LR Window up/dn N/A
RR Window up/dn N/A
Sun Roof open/close motor part of module
Sun Roof Limit/close N/A
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: 555U
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Standard on all models.
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
