2005 Alitma Speed Pulse Wire

I'm trying to install my Eclipse AVN5495, and I need to connect a lead to my Speed Pulse Wire near the ECU.  I'm not Sure what color wire I need to splice into, only online info I've found is for a 2002 maxima.

DIRECTWIRE™ WIRING INFORMATION - NISSAN / ALTIMA / 2005 / Accessory


12volts green (40A)   +   ignition harness
Ignition BLACK/ red   +   ignition harness
Parking Lights+ RED / blue   +   driver kick, harness to rear
Parking Lights- N/A       
Headlight blue (L), RED / yellow (R)   +   IPDM E/R, gray 16 pin plug
Notes: The IPDM E/R (Intelligent Power Distribution Module Engine Room) is under the hood behind the passenger side headlight.
Trunk/Hatch Release RED / black or blue/red   -   BCM to right of fuse box, pin 30
Power Sliding Door N/A       
Speed Sense pink or black      radio harness (Midline or BOSE only)
Notes: On vehicles without the 5 speed automatic transmission, can also use blue / YELLOW behind the instrument cluster.
Wipers blue (L), blue/black (H)   +   IPDM E/R, gray 16 pin plug
Notes: The IPDM E/R (Intelligent Power Distribution Module Engine Room) is under the hood behind the passenger side headlight.
LF Window up/dn blue/red - blue/white   A   driver window switch in door
RF Window up/dn green - yellow   A   driver kick, door harness
Notes: If vehicle has auto up/down on the front passenger window switch then must go into the passenger door and use blue for up and GREEN/ black for down.
LR Window up/dn purple - blue   A   driver kick, door harness
RR Window up/dn RED / yellow - yellow/black   A   driver kick, door harness
Sun Roof open/close motor part of module       
Sun Roof Limit/close N/A       
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: 555U
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.

Great Info; I just got done installing the unit, it's sweet.  The speed pulse wire for the factory Bose system is on the larger of the 4 connection ends, it's pink with strips of silver running through it.