03 outlander wiring
Printed From: the12volt.comForum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62936
Printed Date: April 20, 2024 at 4:47 AM
Topic: 03 outlander wiring
Posted By: mightey14
Subject: 03 outlander wiring
Date Posted: September 19, 2005 at 9:58 PM
Replies:
Posted By: thepencil
Date Posted: September 22, 2005 at 11:37 AM
DIRECTWIRE™ WIRING INFORMATION - MITSUBISHI / OUTLANDER / 2003 / Remote Start
12volts blue/white (40A) + ignition harness
Starter BLACK / YELLOW + ignition harness
Second Starter N/A
Ignition blue/black + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory blue/red + ignition harness
Second Accessory blue / YELLOW + ignition harness
Keysense RED / blue ignition harness
Notes: This wire rests at ground with the key out of the ignition cylinder, and goes to an open circuit when the key is inserted.
Power Lock lt. GREEN/ red - ETACS ECU, pin 33
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock BROWN / red - ETACS ECU, pin 34
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor blue/black 5wi 28 pin plug above fuses, pin 19
Unlock Motor blue/white 5wi ETACS ECU, pin 22
Notes: The ETACS ECU is attached to the back of the fuse box.
Parking Lights+ GREEN / WHITE + 15 pin plug below fuses, pin 2
Parking Lights- N/A
Hazards green - ETACS ECU, pin 55
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L) GREEN/ YELLOW + 15 pin plug below fuses, pin 8
Turn Signal(R) GREEN/ red + 15 pin plug below fuses, pin 13
Reverse Light RED / green + 38 pin plug in driver kick, pin 8
Door Trigger brown - 15 pin plug below fuses, pin 10
Dome Supervision red - 3 pin plug below fuses, pin 1
Trunk/Hatch Pin common with door trigger wire
Hood Pin N/A
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm lt. GREEN/ red - ETACS ECU, pin 42
Notes: Meter this wire while turning the key in the driver door key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm BROWN / white - ETACS ECU, pin 25
Notes: Meter this wire while turning the key in the driver door key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock see factory alarm disarm
Tachometer WHITE/ green ac engine speed detection connector
Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood.
Can also go to one of the ignition coils and use the BLACK/ blue or WHITE/ blue wire.
Can also go to any fuel injector and use the wire that is NOT red.
Wait to start N/A
Brake Wire blue/orange + brake pedal switch
Parking Brake yellow - parking brake switch
Horn Trigger lt. GREEN/ black - ETACS ECU, pin 44
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
12volts blue/white (40A) + ignition harness
Starter BLACK / YELLOW + ignition harness
Second Starter N/A
Ignition blue/black + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory blue/red + ignition harness
Second Accessory blue / YELLOW + ignition harness
Keysense RED / blue ignition harness
Notes: This wire rests at ground with the key out of the ignition cylinder, and goes to an open circuit when the key is inserted.
Power Lock lt. GREEN/ red - ETACS ECU, pin 33
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock BROWN / red - ETACS ECU, pin 34
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor blue/black 5wi 28 pin plug above fuses, pin 19
Unlock Motor blue/white 5wi ETACS ECU, pin 22
Notes: The ETACS ECU is attached to the back of the fuse box.
Parking Lights+ GREEN / WHITE + 15 pin plug below fuses, pin 2
Parking Lights- N/A
Hazards green - ETACS ECU, pin 55
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L) GREEN/ YELLOW + 15 pin plug below fuses, pin 8
Turn Signal(R) GREEN/ red + 15 pin plug below fuses, pin 13
Reverse Light RED / green + 38 pin plug in driver kick, pin 8
Door Trigger brown - 15 pin plug below fuses, pin 10
Dome Supervision red - 3 pin plug below fuses, pin 1
Trunk/Hatch Pin common with door trigger wire
Hood Pin N/A
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm lt. GREEN/ red - ETACS ECU, pin 42
Notes: Meter this wire while turning the key in the driver door key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm BROWN / white - ETACS ECU, pin 25
Notes: Meter this wire while turning the key in the driver door key cylinder.
The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock see factory alarm disarm
Tachometer WHITE/ green ac engine speed detection connector
Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood.
Can also go to one of the ignition coils and use the BLACK/ blue or WHITE/ blue wire.
Can also go to any fuel injector and use the wire that is NOT red.
Wait to start N/A
Brake Wire blue/orange + brake pedal switch
Parking Brake yellow - parking brake switch
Horn Trigger lt. GREEN/ black - ETACS ECU, pin 44
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.