2001 Toyota Celica Alarm/Remote Start Wiring
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=6902
Printed Date: May 03, 2025 at 3:34 PM
Topic: 2001 Toyota Celica Alarm/Remote Start Wiring
Posted By: Mister*E
Subject: 2001 Toyota Celica Alarm/Remote Start Wiring
Date Posted: December 19, 2002 at 9:16 PM
I need help I am trying to figure out how to correctly wire a remote start for a 2001 celica gts.It comes standerd with the factory alarm.I am having trouble with that.Thank you anyone for help.
Replies:
Posted By: Velocity Motors
Date Posted: December 20, 2002 at 11:16 PM
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|blk/red & white |+ |ignition harness |
| STARTER|BLACK/ white |+ |ignition harness |
| IGNITION|BLACK/ orange *1 |+ |ignition harness |
| SECOND IGNITION|blue/red *4 |+ |ignition harness |
| ACCESSORY|gray |+ |ignition harness |
| POWER LOCK|brown |- |passenger kick or BCM *2 |
| POWER UNLOCK|yellow/black |- |passenger kick or BCM *2 |
| LOCK MOTOR|blue/white | |driver kick or BCM *2 |
| UNLOCK MOTOR|blue | |driver kick or BCM *2 |
| DISARM DEFEAT|blue/red | |passenger kick or BCM *2 |
| PARKING LIGHTS +|use the (-) wire | | |
| PARKING LIGHTS -|lt. green | |steering column |
| HEADLIGHTS|RED / blue |- |steering column |
| DOOR TRIGGER|RED / white *3 |- |drivers kick |
| DOME SUPERVISION|RED / white |- |driver kick |
| TRUNK/HATCH PIN|lt. green |- |trunk light or BCM *2 |
| FCTRY ALARM ARM|arms with lock | | |
|FCTRY ALRM DISARM|disarms with unlock | | |
| TACHOMETER|BROWN / white | |rear of instrument cluster |
| SPEED SENSE|WHITE/ red | |rear of instrument cluster |
| BRAKE WIRE|GREEN / WHITE |+ |brake switch |
| HORN TRIGGER|blue/black |- |steering column or BCM *2 |
| WIPERS|blu/yel & blu/orn |+ |steering column |
| LF WINDOW UP/DN|green - red | |power window switch |
| RF WINDOW UP/DN|blue - wht/blu | |power window switch |
| SUN RF OPN/CLOSE|not recommended | | |
| RADIO 12V|blue / YELLOW |+ |radio |
| RADIO GROUND|brown |- |radio |
| RADIO SWITCH|gray |+ |radio |
| RADIO ILLUMINATE|green |+ |radio |
Notes:
*1 When doing remote start, this wire must be isolated from the keyswitch with the ignition relay. See direct fax document #1077. *2 The BCM is located just to the right side of the radio. Remove the radio to access. *3 To avoid dome light delay, use RED / yellow at the driver door pin for the driver door and red at the passenger door pin for the passenger door. Isolate each door trigger with diodes. *4 There are 2 blue/red wires in the ignition harness. The correct ignition wire is the heavier gauge one and it has 1 silver hash mark. The incorrect wire has 2 silver hash marks.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Mister*E
Date Posted: December 21, 2002 at 10:40 PM
Jeff, Thank you for your reply,i am sure it will come in very handy.I have a few questions about it for you.First,I noticed that the factory alarm is armed by the doors locking,the remote start i have is activated by pressing the lock button three times.How do i work around this?I was told if i find the Keysense wire and and hook up the wire on my remote start that sends out a negative pulse that ,that will work.do you have any other suggestions?The other Question I have for you was, on the reply you sent me on the bottom in the notes section,for note *1 it said "When doing remote start,this wire mut be isoleted from the keyswitch with the ignition.See direct fax document # 1077." What is that?Thank you very much for your help,Rob
-------------
Mister*E
|